HP R-3A, R-2A, R-2 MD01, R-2 RDR manual RPC’s main menu allows the user to

RPC SERIES OWNER’S MANUAL

DETAILED OPERATION AND CONFIGURATION

________________________________________________________________________________

Using the 9FRJ45PC-1 adapter (or other applicable adapter) and the RJ08X007 crossed cable, connect the serial port of your computer to the RJ-45 port labeled “EIA- 232” on the back of your RPC unit.

	Load serial port communications software.
	Configure host terminal’s serial
	communications parameters to match the
	RPC. RPC factory serial communications
	parameters are 9600 bps, 8 data bits, 1 stop
	bit, and no parity.
OPERATION	The RPC’s main menu allows the user to
	monitor and control the equipment attached
	to each of the RPC-2 and RPC-2A’s six
	receptacles. From this menu, you can turn
	on, turn off, or reboot attached equipment,
	individually, or all equipment,
	simultaneously.
	The RPC recognizes three basic operating
	commands: ON n<cr>, OFF n<cr>, and
	REBOOT n<cr>, where n represents the
	outlet number and <cr> represents a carriage
	return.
	There are six red LEDs on the front of the
	RPC unit. There is a corresponding red
	LED for each of the RPC’s six receptacles.
	If any or all of the LEDs are illuminated,
	corresponding receptacle(s) are turned
	"ON," and consequently, attached
	equipment is receiving power. If
	any or all of the LEDs are not illuminated,
	corresponding receptacle(s) are turned
	“OFF.”

20