HP R-3A, R-2A, R-2 MD01, R-2 RDR manual Responding Y for yes turns On Outlet

RPC SERIES OWNER’S MANUAL

DETAILED OPERATION AND CONFIGURATION

________________________________________________________________________________

If the status menu fails to appear, ensure the correct cables and adapters are being used and that they are connected properly. Also, verify the serial communication parameters are correctly configured.

Controlling Receptacles	To set or change the status of receptacles,
	enter one of the following commands: ON
	n, OFF n, REBOOT n, where “n” is the
	outlet number you want to command.
	Entering an outlet number of “0” sends the
	command to all outlets.
Example:	To turn “On” Outlet 3, type ON 3 from the
	RPC prompt (RPC >). The RPC responds:
	Turn On Outlet 3 (Y/N)?
	Responding “Y” for yes turns “On” Outlet 3.
	Observe that the status of Outlet 3 has
	changed to On in the status menu:

RPC-2 Series

(c)1997 by BayTech

F2.07

Circuit Breaker : On

1) . . . OUTLET 1	: Off
2) . . . OUTLET 2	: Off
3) . . . OUTLET 3	: On
4) . . . OUTLET 4	: Off
5) . . . OUTLET 5	: Off
6) . . . OUTLET 6	: Off
RPC >

Likewise, typing ON 0 at the RPC > prompt and responding “Y” for yes, turns “On” all outlets. Typing OFF n at the RPC > prompt turns off corresponding outlet(s).

30