HP R-2 MD01, R-2A, R-3A, R-2 RDR manual RPC’s main menu allows you to

RPC SERIES OWNER’S MANUAL

DETAILED OPERATION AND CONFIGURATION

________________________________________________________________________________

OPERATION	The RPC’s main menu allows you to
	monitor and control equipment attached to
	each of the RPC-2 RDR and RPC-2 MD01’s
	six receptacles. From this menu, you can
	turn on, turn off, or reboot attached
	equipment, individually, or all equipment,
	simultaneously.
	The RPC recognizes three basic operating
	commands: ON n<cr>, OFF n<cr>, and
	REBOOT n<cr>, where n represents the
	outlet number.
	There are six red LEDs on the front of the
	RPC unit. There is a corresponding red
	LED for each of the RPC’s six receptacles.
	When the LEDs are illuminated,
	corresponding receptacle(s) are turned
	"ON," and consequently, attached
	equipment is receiving power. If the LED’s
	are not illuminated, corresponding
	receptacle(s) are turned “OFF.”
Accessing Main Menu	Power on the RPC unit. The following
	outlet and circuit breaker status menu
	appears:

RPC-2 Series

(c)1997 by BayTech

F2.07

Circuit Breaker : On

1) . . . OUTLET 1	: Off
2) . . . OUTLET 2	: Off
3) . . . OUTLET 3	: Off
4) . . . OUTLET 4	: Off
5) . . . OUTLET 5	: Off
6) . . . OUTLET 6	: Off
RPC >

29