HP C6180, C6150 manual If you do not see your network name in the list

Page 18

For information on how to open the access point EWS, see the access point documentation.

Note If the network is set up with an Apple AirPort base station and you are using a password instead of WEP HEX or WEP ASCII to access this network, you need to get the equivalent WEP key. See the documentation that came with the Apple AirPort base station for more information.

2.On the control panel of the HP All-in-One, press Setup.

3.Press until Network is highlighted, and then press OK.

4.Press to highlight Wireless Setup Wizard, and then press OK.

This runs the Wireless Setup Wizard. The setup wizard searches for available networks, and then displays a list of detected network names (SSIDs). The networks with the strongest signal appear first, the weakest appear last.

The wireless network test also runs, performing a series of diagnostic tests to determine whether network setup is successful. The wireless network test prints upon completion of the test.

5.Press to highlight the name of the network you wrote down in step 1, and then press OK.

If you do not see your network name in the list

a.Select Enter a New Network Name (SSID). If necessary, use theto highlight it, and then press OK.

The visual keyboard appears.

b.Enter the SSID. Use the arrow buttons on the HP All-in-One control panel to highlight a letter or number on the visual keyboard, and then press OK to select it.

Note You must enter the exact uppercase (capital) and lowercase (small) letters. Otherwise, the wireless connection will fail.

c.When you are finished entering the new SSID, use the arrow buttons to highlight Done on the visual keyboard, and then press OK.

d.Press until Infrastructure is highlighted, and then press OK.

e.Press until WEP encryption or WPA encryption is highlighted, and then press OK.

If you do not want to use WEP encryption, pressuntil No, my network does not use encryption is highlighted, and then press OK. Go to step 7.

6.If prompted, enter your WPA or WEP key as follows:

a.Use the arrow buttons to highlight a letter or number on the visual keyboard, and then press OK to select it.

Note You must enter the exact uppercase (capital) and lowercase (small) letters. Otherwise, the wireless connection will fail.

b.When you are finished entering the WPA or WEP key, use the arrow buttons to highlight Done on the visual keyboard.

Network setup

Basics Guide

15

Image 18

Contents HP Photosmart C6100 All-in-One series Basics Guide Hewlett-Packard Company notices Contents Index Copy Print photosPrint from your computer ScanHP All-in-One at a glance Label DescriptionControl panel features Label Name and Description Use the HP Photosmart software Access the onscreen Help Find more informationHP Photosmart Mac Help appears Wired network setup If you want toSee this section What you need for a wired network Connect the HP All-in-One to the networkInstall the software for a network connection To connect the HP All-in-One to the networkTo install the Windows HP All-in-One software To install the Mac HP All-in-One softwareIntegrated wireless Wlan 802.11 network setup What you need for an integrated wireless Wlan 802.11 networkConnect to an integrated wireless Wlan 802.11 network To connect the HP All-in-One with the Wireless Setup WizardIf you do not see your network name in the list Wireless ad hoc network setup What you need for an ad hoc networkPrepare a Windows XP computer On the Windows Control Panel, click Security Center To disable LAN connections with Windows XPTo prepare your computer To create a network profilePrepare a Mac To create a new network profileCreate a network profile for other operating systems Select Create Network…Click Show Options Connect to a wireless ad hoc network Communication mode Ad Hoc Encryption enabledTo connect to a wireless ad hoc network Connect to additional computers on a network Manage your network settings Change basic network settings from the control panelTo run the Wireless Setup Wizard To restore network defaults To view and print the network settingsRestore network defaults Turn the wireless radio on and offAutomatic Full Half To access the Embedded Web Server IP Address Subnet Mask Default GatewayAccess the Embedded Web Server Use the Embedded Web ServerTo access the Embedded Web Server setup wizard Network configuration page definitionsUse the Embedded Web Server setup wizard General network settingsWired 802.3 network settings ParameterWhen you use the web or send an e-mail message, you use a Wireless 802.11 network settings Plugged in and connected to an active network Ssid Parameter Bluetooth settings Set up the HP All-in-One for faxing Countries/regions with a parallel-type phone systemChoose the correct fax setup for your home or office USASelect your fax setup case Other equipment/ services sharing your fax line Recommended fax setup for parallel-type phone systemsRecommended fax setup for serial-type phone systems Up modem, and answering ServiceNot applicable MachineCase a Separate fax line no voice calls received Case B Set up the HP All-in-One with DSLTo set up the HP All-in-One with a separate fax line Back view of the HP All-in-OneTo set up the HP All-in-One with DSL Fax setup Case D Fax with a distinctive ring service on the same line To set up the HP All-in-One with a distinctive ring serviceTo set up the HP All-in-One with a shared voice/fax line Case E Shared voice/fax lineCase F Shared voice/fax line with voice mail To set up the HP All-in-One with voice mail To set up the HP All-in-One with a computer dial-up modemCase H Shared voice/fax line with computer dial-up modem Example of a parallel splitter Fax setup Case I Shared voice/fax line with answering machine Answering machineFax setup Example of a parallel splitter Fax setup Example of a parallel splitter Change settings on the HP All-in-One to receive faxes Set the answer modeTo set the answer mode Set the number of rings before answeringChange the answer ring pattern for distinctive ringing To set a default fax header from the control panel Test your fax setupTo test your fax setup from the control panel Set the fax headerFax setup Load originals and load paper Load an original in the automatic document feederTo load an original in the document feeder tray Load an original on the glass Load 10 x 15 cm 4 x 6 inch photo paperTo load an original on the glass Avoid paper jams To load 10 x 15 cm 4 x 6 inch photo paper in the photo trayScan an original to a computer Make a copyScan an image To make a copy from the control panelPress OK to select Select Computer Make reprints of your photosPress Scan Menu Press ReprintsPrint Options Defaults optionScan an original to a memory card or storage device Print PreviewPrint 10 x 15 cm 4 x 6 inch photos To print one or more 10 x 15 cm 4 x 6 inch photosTo edit the selected photo before printing Print from a software applicationTo print more than one copy of the selected photo To select additional photos for printingTo print from a software application Windows To print from a software application MacTo send a basic fax from the control panel Send a basic faxReplace the ink cartridges Press Fax MenuTo replace the ink cartridges Use the HP All-in-One features Clean the HP All-in-One Align the printerTo align the printer from the control panel Clean the glass To clean the glassClean the lid backing Clean the exteriorTo clean the lid backing Uninstall and reinstall the software Troubleshooting common setup issuesTo uninstall from a Windows computer and then reinstall Hardware setup troubleshooting To uninstall from a Mac and then reinstallHP All-in-One will not turn on Display shows the wrong language To set your language and country/regionFax setup troubleshooting Wrong measurements are showing in menus on the displayFax Connected to Active Telephone Wall Jack test failed Fax test failedFax Hardware Test failed What to doPhone Cord Connected to Correct Port on Fax test failed Using Correct Type of Phone Cord with Fax test failed Dial Tone Detection test failed Fax Line Condition test failed HP All-in-One is having problems sending and receiving faxes Troubleshooting and support Troubleshooting and support Try setting the Fax Speed to Medium 14400 or Slow If you hear noise, do the following HP All-in-One cannot send faxes, but can receive faxesHP All-in-One is having problems sending a manual fax HP All-in-One cannot receive faxes, but can send faxes Telephone wall jack Troubleshooting and support Fax tones are recorded on my answering machine Telephone wall jack Network troubleshooting Wired network setup troubleshootingTo establish an active network connection Received a System Requirements Error No TCP/IPPrinter not Found screen appears during installation To make sure your network connection is activeWireless setup troubleshooting To print the network configurationYou do not see the Ssid Weak signal Error message Cannot connect to networkError message Invalid WEP Key Cause An invalid WEP key was enteredNetwork software installation troubleshooting Error message Invalid passphraseError message More than 1 SecureEZ Setup access point found Clear paper jams To clear a paper jam from the rear doorTo clear a paper jam in the automatic document feeder Ink cartridge messages Calibration errorInformation on ink cartridges Cannot printInk cartridges are expired Ink cartridge problemInk cartridges are empty Ink expiration nearPrint head assembly is stalled Non-HP inkOriginal HP ink depleted Printer alignment failed To clear the print head assemblyPrint head failure Replace ink cartridges soonWrong ink cartridges installed HP support by phone Additional warranty optionsSupport process Phone support period Placing a callSystem requirements Paper specificationsPrint specifications Paper tray capacitiesFax specifications Copy specificationsScan specifications Physical specificationsRegulatory notices Environmental specificationsInk cartridge warranty information Regulatory model identification numberWarranty Index Left arrow Basics Guide 113 114

Related manuals

Manual 16 pages 14.64 Kb