Network setup
Chapter 2
4.Click the Home tab to access device and network information, or click the Networking tab to access more network information or to modify network information.
5.Make any configuration changes.
6.Close the Embedded Web Server.
Use the Embedded Web Server setup wizard
The network setup wizard provided in the Embedded Web Server gives you an intuitive interface to your network connection parameters.
To access the Embedded Web Server setup wizard
1.Print a network configuration page to find the IP address for the HP
2.In the Address box in your Web browser on your computer, type the IP address of the HP
The Embedded Web Server Home page appears, showing information for the HP
Note If you are using a proxy server in your browser, you might need to disable it to access the Embedded Web Server.
3.Click the Networking tab.
4.Click Wired (802.3) in the Connections navigation menu.
5.Click Start Wizard, and then follow all of the wizard instructions.
Network configuration page definitions
The network configuration page shows the network settings for the HP
General network settings
The following table describes the general network settings shown on the network configuration page.
Parameter | Description | |
|
| |
Network Status | Status of the HP | |
| ● Ready: The HP | |
| ● Offline: The HP | |
| network. | |
|
| |
Active | Network mode of the HP | |
connection | ● Wired: The HP | |
type | ||
IEEE 802.3 network. | ||
| ||
| ● Wireless: The HP | |
| network. | |
| ● None: There is no network connection. | |
|
| |
URL | The IP address of the Embedded Web Server. |
26 | HP Photosmart C6100 |