R
Mt. Vernon Pellet Insert (AE)
M. Quick Start Guide
NOTICE: Any button pressed will turn on the backlight. Wall control will automati- cally revert back to the starting screen if there is no activity for 15 seconds; except for the “CONFIRM FUEL CHANGE” screen.
Buttons
CHOOSING FUEL TYPE
READY | 12:30 PM |
CHOOSING TEMP UNIT:
°F or °C
| READY |
|
|
|
| 12:30 PM | Up | ||||
|
|
|
|
|
|
|
|
|
|
|
|
Room | 73 |
|
|
|
|
|
|
| Set at: 73 | Down | |
|
|
|
|
|
|
|
| ||||
|
|
|
|
|
|
|
| ||||
|
|
|
|
|
|
|
| ||||
Temp |
| MENU |
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
| HEAT OUTPUT | ||||
71 
Set at: 68
READY |
| 12:30 PM |
MENU
71 
Set at: 68
Function Buttons
Wall Control for Reference
TURNING ON APPLIANCE
READY |
| 12:30 PM |
1.At the starting screen, press “MENU” button once or twice until “MENU” screen appears.
MENU
Set Comfort Level
Auto/Manual/Off
Fuel Type
User Settings
MENU
1.At the starting screen, press “MENU” button once or twice until “MENU” screen appears.
MENU
Set Comfort Level
71
MENU
Set at: 68
2.Highlight “FUEL TYPE” using the “UP/ DOWN” buttons to the right side of the display. Press “SELECT”.
Auto/Manual/Off
Fuel Type
User Settings
1.At the starting screen, press “MENU”.
MENU
Set Comfort Level
Auto/Manual/Off
Fuel Type
User Settings
2.Highlight “AUTO/MANUAL/OFF”. Press “SELECT”.
AUTO/MANUAL SETTINGS
Automatic
Manual
Off
3.Highlight “MANUAL”. Press “SELECT”.
4.Press “DONE” twice or wait 15 sec- onds for starting screen to
FUEL SELECTION
Softwood Pellet
Sunflower Seeds
Wheat
Hardwood Pellet
3.Scroll down and highlight “HARD- WOOD PELLET” or your fuel type.
4.Now press “SELECT” to choose new fuel.
CONFIRM FUEL CHANGE
Please empty hopper
of old fuel type and
ensure firebox is clean.
Please refer to
section 8 in manual.
DONE
5.Press “DONE” to confi rm fuel change.
6.Press “DONE” twice or wait 15 sec- onds for starting screen to reap- pear.
7.Fill the hopper with fuel. If the hop- per was completely empty or has run out of fuel, put approximately 1/2 cup of pellets into the fi repot for a quick restart.
8.Be sure the hopper lid and glass door are both closed.
2.Highlight “USER SETTINGS” using the “UP/DOWN” buttons to the right side of the display. Press “SELECT”.
USER SETTINGS
Temp Units F/C
Flame Height Adjust
Temp Differential
3.Highlight “TEMP UNITS F/C” using the “UP/DOWN” buttons to the right side of the display. Press “SELECT”.
4.Press the “UP” or “DOWN” button to set desired temperature unit and press “SELECT”..
5.Press “DONE” twice again, or wait 15 seconds for starting screen to
November 22, 2011 |
Page 31