Quadra-Fire MTVERNINSAE-CSB, MTVERNINSAE-PMH, MTVERNINSAE-MBK, MTVERNINSAE-CWL owner manual 74ºF

Mt. Vernon Pellet Insert (AE)

R

SETTING COMFORT LEVEL

READY				12:30 PM
			Set at: 68
71
	MENU
		HEAT OUTPUT

1.Press and hold “UP” or “DOWN” but- ton to set desired temperature.

NOTE: Set temperature must be 3 degrees higher than room temperature for appliance to start.

74ºF

2.Press “HOLD TEMP”.

SET COMFORT LEVEL

74ºF

ON HOLD

DONE RESUME

3.Press “DONE”.

SETTING HEAT OUTPUT

READY			12:30 PM
		HoldSet at:		74
71
	MENU
		HEAT OUTPUT

1.At the starting screen, press “HEAT OUTPUT”.

Medium High

2.Use the “UP” button to change “HEAT OUTPUT LEVEL” to ”MEDIUM-HIGH”.

3.Press “DONE” twice or wait 15 seconds for starting screen to re-appear.

HOPPER OUT OF FUEL

ERROR LIST

Min Firepot Temp

RETRY SERVICE

1.If the appliance has stopped operat- ing, check the wall control screen. If it is showing “Min Firepot Temp” the hopper has run out of fuel.

2.Fill the hopper with fuel and press the “RETRY” button twice. The fi rst time turns on the back light, the second time starts the retry function.

SHUTDOWN			12:30 PM
		HoldSet at:		74
71
	MENU
		HEAT OUTPUT

3.If the wall control screen changes to a “SHUTDOWN” screen that means your appliance has not completed the full shutdown cycle. Depending on where it was in the cycle it can take from one to ten minutes to restart.

When the shutdown cycle is complete the wall control screen will display “STARTUP”. Continue to Step 4.

STARTUP			12:30 PM
		HoldSet at:		74
71
	MENU
		HEAT OUTPUT

4.If the wall control screen changes to a “STARTUP” screen after pressing “RETRY” that means your appliance has already completed the shutdown cycle. You must wait until the wall con- trol screen displays the startup screen and then put 1/2 cup of pellets in the fi repot for a quick restart.

5.Be sure the hopper lid and glass door are both closed.

Page 32 7036-135G November 22, 2011