HBDV7 Series Direct Vent Gas FireplaceSIGNATURE COMMAND SYSTEM OPERATION INSTRUCTIONS
FEATURES
Command Center
•Easy Access Function Operation and System Configuration
•Operation Confirmation/Fault Diagnostic Indications (LED/ Buzzer)
•ON/OFF/HI/Med/Low Operation
•Optional Wall Mounting
Control Board
•Electronic Ignition
•Pilot Lockout safety feature
•Electric Power Regeneration from Thermopile to save bat- tery
•
•Convenient NG/LP Gas Type Conversion
•Standing Pilot/Intermittent pilot Conversion
•Previous settings Restoration Ability (Memory Off)
•Uninterrupted Operation During Power Outage (Automatic Battery Backup)
•ON/OFF RF Remote Receiver
•Optional Transmitter Learn Capability
RF Receiver | To Thermopile |
| |
ON/OFF | To Sensor |
| To Sparker |
NG/LP
Conversion
| To Command Center |
Control |
|
Board | To Stepper Motor |
| To Valve |
OFF
LED
ON
Master Switch
Command
Center
AC Module Board (Optional, requires TSFSC Remote)
Battery Door
• | Easy | Figure 58 - | |
• | Embedded Compact 120 VAC Adapter with Auto Battery | ||
Signature Command System Components | |||
| Back up Feature |
|
•Remote Controlled
Transmitter (Optional) |
|
|
|
|
|
TSFSC | TSTSC | TSMSC | RTSC | RMSC | |
Three Flame Height Settings | X | X | X | X | X |
Low battery Indication for Transmitter | X | X | X | X | X |
Child Proof | X | X | X | X | X |
LCD Backlight | X | X | X | X | X |
Security Codes 16 | X | X | X | X | X |
Countdown 6 hr Timer | X | X | X | ||
Standard Thermostatic Control Mode | X | X | X | ||
Smart Mode Thermostat (Auto Flame & Blower Modulation) | X | X | |||
Three Brightness Settings for Lights | X | ||||
Three Speed Control for Blower | X | ||||
On/Off Auxiliary | X | ||||
Programmable Timer to turn blower on and off | X | ||||
BATTERY INSTALLATION
The Command Center uses four (4) "AA" batteries as back up for power outages. The system can operate for approxi- mately six (6) months on battery power.
To Install Batteries (not included):
1.Press down the battery door tabs and pull out to remove battery door.
2.Install the batteries as indicated on Command Center.
3.Close battery door by snapping in place.
4.When the four (4) batteries are installed the system will operate without power.
5.The batteries should be replaced when the LED indicates low battery or at least once a year.
38 | 54D8000 |