Site Preparation and Installation
Figure 13 Indoor air-cooled centrifugal condensing unit dimensions and pipe connections
Customer supplied threaded rods for module support from ceiling (1/2" minimum diameter recommended) (typ. 4).
13/16"
(21mm)
66 9/32 " (1683.5mm)
CABINET
DIMENSION
1 13/16 " (40mm)
59 13/16 " (1519mm)
40 5/32 " (1020mm)
CABINET DIMENSION
19 1/32 " |
|
(483mm) | 8 13/16 " |
| (224mm) |
1 3/32 " (26mm)
23 7/8 " (606mm)
42 17/32 " (1080.3mm)
THREADED ROD
CENTERS
64 1/4 " (1632mm)
THREADED ROD
CENTERS
16 5/16 " (414mm)
26 3/8 " (670mm)
Shaded area indicates a recommended clearance of 30" (762mm)for component
Hanger access and removal. Bracket
NOTE: Unit is spaced evenly in |
|
reference to threaded | 9/16" (14mm) dia. holes for |
rod centers. | threaded rods (typ. 2 each end) |
Air Inlet
Single Point Power Kit connection from Evaporator.
System 1 (3Ton) Suction Line Connection,
Aeroquip #11 Male.
System 2 (5Ton) Suction Line Connection,
Aeroquip #12 Male.
System 1 (3Ton) Liquid Line Connection,
Aeroquip #6 Male.
Air Outlet
7/8" (22mm) & 1 1/8" (29mm) dia. knockouts electrical entrance for high voltage connection
System 2 (5Ton) Liquid Line Connection,
Aeroquip #10 Male.
7/8" (22.2mm) dia. knockout electrical entrance for alternate control panel low voltage routing.
7/8" (22.2mm) dia. electrical entrance for low voltage connection.
DPN000248_Rev1
21