Jotul GF 100 DV II, GF 200 DV II manual Date of Purchase, Name of Installer

Page 23

Figure 33. Removal and replacement of the glass panel.

Figure 34. Wrap the gasket around the glass panel.

Always replace any damaged or broken parts with JØTUL AUTHORIZED PARTS ONLY. These are available through your Jøtul dealer. Never use any substitute parts on your stove.

With proper care and maintenance your appliance will provide you with many years of enjoyment. If you experience any problems or inconsistency with your stove, contact your authorized Jøtul dealer for assis- tance.

RETAIN THIS MANUAL FOR REFERENCE AND MAKE IT AVAILABLE TO ANYONE USING OR SERVICING THE STOVE.

GF 100 DV II Nordic QT

GF 200 DV II Lillehammer

Record the following information to help your dealer determine what you will need for parts and service.

MODEL NAME: ________________________

SERIAL NUMBER: ______________________

DATE OF PURCHASE: ___________________

PURCHASED FROM: ____________________

NAME OF INSTALLER: ___________________

TYPE OF FUEL: ________________________

WAS STOVE CONVERTED? _______________

NOTES:

23

Image 23
Contents Installation and Operation Instructions Welcome to Jøtul Table of Contents Input Rates Jøtul GF 100 DV II Nordic QT SpecificationsGF 100 DV II Miscellaneous Kit Contents GF 100 DV II AccessoriesGF 200 DV II Miscellaneous Kit Contents Jøtul GF 200 DV II Lillehammer SpecificationsRemove the Glass Panel Stove SetupSuggested Tools for Installation and Service Remove the Top PlateGlass Front Safety InformationLocation Hearth RequirementsAlcove Installation Vertical Termination Venting RequirementsIntake Air Restriction Horizontal TerminationHorizontal RUN Vertical Vent TerminationVenting Through a Fireplace Co-linear Vent InstallationThese installation requirements must be followed Min. / Max. Horizontal Run Horizontal Vent TerminationHorizontal Termination with Vertical Rise Wall Shield InstallationMin inches, U.S. / *12 inches 30 cm can Horizontal Termination ClearanceTools required Mobile Home InstallationConversion Kit Contents Never USE AN Open Flame to Check for GAS Leaks Gas Conversion ProcedureLeak test Gas Supply ConnectionInches water column High Altitude AdjustmentGas Pressure To adjust the air shutter Flame Appearance Air Shutter AdjustmentHigh Altitude Orifice Chart GF 200 DV II Only Derating ProcedureRemote Control Optional Wall Thermostat or Remote ControlLog Set Installation Proper pilot flame appearance System CheckOperation MaintenanceGlass and Gasket Replacement Only Use Replacement KitDate of Purchase Name of InstallerOptional Blower # InstallationSnapstat terminal. See figs.35 Connect power cord to the nearest outletBlower Operation Attach the Blower to the stove47a 47b 47b Parts List GF 100 DV II / GF 200 DV II Firebox Assembly47a GF 100 DV II Nordic QT GF 200 DV II Lillehammer GF 100 DV II Nordic QT Cast Iron Parts ListReplace the Glass Frame Optional Antique Brick Panel Kit InstallationInstall the Lower Panel Install the Logset. Refer to pgControl Valve Lighting InstructionsJøtul North America Jøtul AS