GF 100 DV II Nordic QT
GF 200 DV II Lillehammer
Optional
Antique Brick Panel Kit 155815
Installation
CAUTION!
THE BRICK PANELS ARE EXTREMELY FRAGILE. HANDLE WITH CARE. WEAR SAFETY GLOVES TO PROTECT HANDS.
1.Remove the Top Plate. Simply lift it up off of the stove body. It is not fastened.
2.GF 100 DV II ONLY: Remove the Front Plate by lifting straight up to disengage it from the sides.
3.Remove the Glass Frame. Disengage the two trunk latches located at the top of the firebox and lift the glass frame up and out of the firebox.
4.If installed, remove the Logset.
These parts are not fastened. Simply lift them out of the firebox. You do not have to remove the embers.
5.Install the Lower Panel.
Position it up against the back wall, resting on the Burner Skirt. Fig. 43.
6.Install one of the Side Panels, pushing it up against the firebox wall. Fig. 44
7.Position the Upper Panel. You should seat the Upper Panel down and forward so that no gaps are evident at the panel joints, as in Fig. 44.
8.Install the other Side Panel while holding the Upper Panel in position.
Adjust the panels so that the mortar joints align with those adjacent.
9.Install the Logset. Refer to pg. 20.
BE CERTAIN THAT NO EMBERS ARE BLOCKING THE PILOT ASSEMBLY OPENING.
10.Replace the Glass Frame.
Slide the frame down the slot in the front of the firebox. Be sure to push the frame into the slot in the bottom to ensure it is fully seated. The gasket at the top of the frame should be flush with the top of the firebox.
11. Replace the Top Plate.
Tools Required: Safety glasses and gloves
| Upper Panel | |
Left Panel | 221117 | |
Right Panel | ||
221114 | ||
221115 | ||
|
Lower Panel
221116
Figure 42. Brick Panel Kit Contents.
Burner Skirt
Figure 43. Install the Lower Rear Panel
Figure 44 . Install the Upper and Side Panels.
30