Jotul 3 Parts Diagram: GF 100 DV II & GF 200 DV II Manual

GF 100 DV II Nordic QT

GF 200 DV II Lillehammer

Figure 37 . Attach Blower to the stove bottom and connect wires to Snapstat.

Mounting Bracket

for GF100 DV II

Snapstat

Connectors

M6 x 20 mm	#8 x 1/2” sheet
Hex Bolts	metal screws

4. Attach the Blower to the stove.

GF 100 DV II: First install the Mounting Bracket to

the holes in the bottom of the rear shroud using

BLOWER

two #8 x 1/2” sheet metal screws. Then attach the

Blower to the Mounting Bracket using the two M6

flange head hex bolts as shown in fig. 35 and 37.

GF 200 DV II: Attach the Blower directly to the

G	W
	W	BK
		BK

tapped hole in the cast iron stove bottom using the

two M6 flange head hex bolts.

POWER SUPPLY

SNAPSTAT

RHEOSTAT

5.	Attach either Snapstat wire connector to either
	Snapstat terminal. See figs.35 and 37.
6.	Connect power cord to the nearest outlet.

Blower Operation

The variable-speed blower will enhance heat circulation around the firebox and out into the room. The blower is controlled by a heat activated switch (snapstat) that will ONLY function when the control switch is in AUTO setting. After the fire has been burning for a time, the snapstat will react to the heat and activate the blower. Fan speed may be manually adjusted with the rheostat knob. If the burner turns off, the blower will be shut off automatically when the stove cools down.

If automatic blower circulation is not desired, place the blower control switch in the MANUAL position.

GYBK

SWITCH

MANUAL OFF AUTO

Figure 38. Blower Wiring Diagram

CAUTION:

LABEL ALL WIRES PRIOR TO DISCONNEC- TION WHEN SERVICING CONTROLS. WIRING ERRORS CAN CAUSE IMPROPER AND DAN- GEROUS OPERATION.

VERIFY OPERATION AFTER SERVICING.

ATTENTION:

Au moment de l’entrentien des commandes, etiquietez tous le fils avant le debranchement. es erreurs de ceblage peuvent entra tun fonctionnement inadequat et dangereux.