Mounting and Installation
6.Place the lug of the ground wire on the device and the Earth ground wire around the provided screw and connect them both to the point shown in FIG. 17.
The device and wall box must have an Earth ground.
7.Install the (provided) Ferrite clip onto the Ethernet cable (see FIG. 8 on page 12).
8.Connect the Ethernet cable in the back of the Metreau Entry Communicator.
9.Insert and fasten the Metreau Entry Communicator into the wall box.
Start at the top of the device and tilt in toward the bottom.
Removing the Device From the Wall
The installation housing for the Metreau Entry Communicators are made to such exacting specifications it will always be a snug fit. Should you ever need to remove the Metreau Entry Communicator from the wall, follow these steps:
1.Place a flathead screwdriver between the tab of the wall box and the notch of the Metreau Entry Communicator and pop the two apart.
2.Pull the bottom of the unit out (pivoting on the top clip) until it seems to bind against the shielding
3.While keeping the unit at this angle, pull the top of the unit away from the top clip.
24 | Metreau Entry Communicators |