Regency L676-1 Optional Andiron Installation, post, Replace Log G, Replace Log B see below

Page 37
OPTIONAL ANDIRON INSTALLATION
37
Log B
Note: Andiron bracket can be adjusted by bending.
Also the screw can
be loosened so the bracket can be adjusted higher or lower.
Andiron Bracket
4th Grate PostAdjustments
5) For the right side, slide the andiron bracket over the 4th grate post.
6) Reinstall glass door and mesh.
Final Installation L676-1
Optional Andiron installation for the L676-1:
1) Remove the mesh and the glass door (see Page 30 in the manual).
2) Remove Log B from the log set - see below.
Log B
1st Grate Post
INSTALLATION

OPTIONAL ANDIRON INSTALLATION

Optional Andiron installation for the L900-1:

1) Remove the mesh and the glass door (see Page 30 in the manual).

2) Remove Log G from the log set - see below.

 

Log G

3)

Slide the bracket on the back of the andiron over the 1st grate

 

 

3)

Slide bracket on the back of andiron over the 1st grate post.

post.

 

 

4)

Replace Log G.

4)

Replace Log B (see below).

 

 

1st Grate Post

4th Grate Post

Andiron Bracket

Right Side

5) For the right side, slide the andiron bracket over the 4th grate post.

6) Reinstall glass door and mesh.

Final Installation L900-1

Regency® L676-1 Direct Vent Gas Fireplace

INSTALLATION

Image 37
Contents LIBERTY L676-1Gas Fireplace MANUFACTURED MOBILE HOME REQUIREMENTS CongratulationsSAFETY LABEL TABLE OF CONTENTSINSTALLATION WARRANTYINSTALLATION SAFETY LABELINSTALLATION REQUIREMENTSMA Code - CO Detector 5.08: Modifications to NFPA-54,ChapterINSTALLATION UNIT DIMENSIONSRegency L676-1Direct Vent Gas Fireplace GENERAL SAFETY INFORMATION INSTALLATIONINSTALLATION CHECKLIST INSTALLATIONINSTALLATION INSTALLATIONDiagram HEAT RELEASE KITCLEARANCES INSTALLATIONClearance to Combustibles from Minimum Clearance from Top of Front FacingINSTALLATION INSTALLATIONMANTEL CLEARANCES MANTEL LEG CLEARANCESINSTALLATION INSTALLATIONDiagram Diagram DiagramUNIT ASSEMBLY PRIOR TO INSTALLATION INSTALLATIONINSTALLATION FINISHING TEMPLATEINSTALLATION INSTALLATIONVENT RESTRICTOR POSITION Vent Restrictor PlateINSTALLATION INSTALLATIONEXTERIOR VENT TERMINATION REQUIREMENTS Minimum Clearance RequirementsINSTALLATION INSTALLATIONVENTING ARRANGEMENTS FPI Kit #INSTALLATION INSTALLATIONWhen using Rigid Vent other than RIGID PIPE VENTING SYSTEMS5” X 8” RIGID PIPE CROSS REFERENCE CHART INSTALLATIONINSTALLATION INSTALLATION INSTALLATIONRegency L676-1Direct Vent Gas Fireplace INSTALLATION INSTALLATIONVENT RESTRICTOR SETTING VENTING ARRANGEMENTSINSTALLATION INSTALLATIONHorizontal Venting with Two 2 90o Elbows Horizontal Venting with Three 3 90o ElbowsINSTALLATION INSTALLATIONVENT RESTRICTOR SETTING Vertical Venting with Three 3 90o ElbowsINSTALLATION INSTALLATIONVENTING ARRANGEMENTS ALLOWABLE VERTICAL TERMINATIONSUNIT INSTALLATION WITH HORIZONTAL TERMINATION INSTALLATIONINSTALLATION DiagramUNIT INSTALLATION WITH VERTICAL TERMINATION INSTALLATIONINSTALLATION DiagramUNIT INSTALLATION INSTALLATIONINSTALLATION ASTROCAP XL DIMENSIONS 946-623/PPILOT ADJUSTMENT INSTALLATIONGAS LINE INSTALLATION TESTINGAERATION ADJUSTMENT INSTALLATIONWIRING DIAGRAM INSTALLATIONINSTALLATION INSTALLATIONCONVERSION KIT #522-969FROM NG TO LP LP Conversion Kit ContainsINSTALLATION INSTALLATIONNOTE Once the unit has been installed Burner TubeBRICK PANEL INSTALLATION INSTALLATIONINSTALLATION Diagram Right Side Rod with Screen RemovedINSTALLATION INSTALLATIONBurner Orifi ce Cover Plate Diagram DiagramLOG SET INSTALLATION INSTALLATIONINSTALLATION Log kit # 522-930contains the following piecesINSTALLATION INSTALLATION5 Fit log A into the pins on the log tray 7 Fit log E into the pin at the center of log AINSTALLATION INSTALLATIONF BA C 1st Grate PostINSTALLATION INSTALLATIONCompleted Log Set Installation E F A B CMESH PULL SCREEN INSTALLATION INSTALLATIONINSTALLATION Left Side Rod Right Side RodINSTALLATION OPTIONAL ANDIRON INSTALLATIONFinal Installation L900-1 Log GMATCHING REMOTE CONTROL & RECEIVER CODE OPERATING INSTRUCTIONSLIGHTING PROCEDURE SHUTDOWN PROCEDURENORMAL OPERATING SOUNDS OF GAS APPLIANCES OPERATING INSTRUCTIONSCOPY OF LIGHTING PLATE INSTRUCTIONS DO NOT REMOVE THIS INSTRUCTION PLATEMAINTENANCE INSTRUCTIONS MAINTENANCELOG REPLACEMENT GENERAL VENT MAINTENANCEDC SPARK BOX BATTERY REPLACEMENT MAINTENANCEDC SPARK BOX REPLACEMENT MAINTENANCEVALVE TRAY REPLACEMENT MAINTENANCEMAINTENANCE Latch Location LatchMAINTENANCE MAINTENANCEDC Spark Box DC Spark BoxMAIN ASSEMBLY PARTS LISTPARTS LIST Part #PARTS LIST PARTS LISTBURNER & LOG ASSEMBLY PARTS LISTPARTS LIST Part #The Warranty: Limited Lifetime WARRANTYConditions ExclusionsSee the inside back cover for details