Summit 43176 manual GAS Instructions, Locating Your LP Tank Cabinet

4 GAS INSTRUCTIONS

LOCATING YOUR LP TANK CABINET

When determining a suitable location for your LP Tank Cabinet installation, give attention to concerns such as exposure to wind, proximity to traffi c paths, and keeping any gas supply lines as short as possible. Never locate the Summit® LP Tank Cabinet in a garage, breezeway, shed, under an unprotected overhang, or other enclosed area. Locate the LP Tank Cabinet and structure so there is enough room to safely evacuate the area in case of a fi re.

CLEARANCE FROM COMBUSTIBLE SURFACES OR STRUCTURES

WARNING: Clearance from the outside walls of the sides and back of the LP Tank Cabinet must be a minimum of 24 inches (610 mm) from any surface. Refer to “Typical Gas Supply Installation” before starting installation.

WARNING: The structure, “island” counter tops and adjacent work areas for the LP Tank Cabinet installation must be built from noncombustible materials only.

NOTE: If you have questions on what materials are considered noncombustible, contact your local building supplier or fire department.

BUILT-IN STRUCTURE CUTOUT DIMENSIONS

All dimensions are to finished surfaces.

WARNING: All counter top finished surfaces must be constructed of a noncombustible material.

			c
		1
b	1			1	b
			a

BUILT-IN CUTOUT DIMENSIONS

S-440, S-640

1 24” (610 mm) minimum*

aLP Tank Cabinet

bAny Surface

cNon-Combustable Surface

A

B

C

TANK CABINET CUTOUT DIMENSIONS

S-440	TOLERANCES
20 3/4˝ (527.05 mm)	+ 1/4˝	- 1/4˝ (6.35mm)
27 1/2˝ (698.5 mm)	+ 1/4˝	- 1/4˝ (6.35mm)
14˝ (355.6 mm)	+ 1/4˝	- 1/4˝ (6.35mm)

WWW.WEBER.COM®