Wayne-Dalton 5120, 5140 installation instructions Maintenance, Painting

Page 37

Painting Continued....

Painting

After surface has been properly prepared, it must be allowed to dry thoroughly, and then coated immediately with premium quality latex house paint. Follow paint label directions explicitly. Oil base or solvent base paints are not recommended. Please note that if substrate is exposed and not properly primed, painting with latex paint may cause accelerated rusting of the steel in the exposed area.

NOTES:

1.Repainting of finish painted steel doors cannot be warranted, as this condition is totally beyond the door manufacturer’s control.

2.Consult a professional coatings contractor if in doubt about any of the above directions.

3.Follow directions explicitly on the paint container labels for proper applications of coatings and disposal of containers. Pay particular attention to acceptable weather and temperature conditions in which to paint.

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer.

37

To find your Wayne-Dalton dealer; refer to your local yellow pages / business listings or go to Find a dealer area online at www.wayne-dalton.com

MAINTENANCE

Image 37

Contents 5120 Table of Contents Package Contents Door Section Identification Tools Required For Standard Lift Torsion Spring RemovalFailure to use approved Winding bars can cause Spring energy to be releasedCounter cover when counting Using an electric drill HighBracket will always have a drive gear Head will be pluggedRemoval TorqueMaster SpringRemoving the Old Door Extension Spring RemovalPreparing the Opening Attaching Quick Install Flag InstallationAngle to Vertical Track Horizontal Angle Installing Q.I. Jamb BracketsBottom Section DrumsStacking Sections Vertical TrackBar Top BracketsOperator Bracket Bar AsymmetricalTop Section To the slot in the flagangle using Tools Needed To install horizontal track, placePortion of horizontal track down to Remove the nail that was temporarilyCenter Bracket Bushing TorqueMaster Spring TubePlug the motor power cord into Opener Idrive InstallationGarage looking out Right hand end of the TorqueMasterCable Drum Installation End Brackets Drive Gear InstallationSecuring Center Bracket Assembly Counter InstallationPositioning Support Bracket Mounting Disconnect Attaching Disconnect CablesHandle Bracket Attaching Disconnect Handle Securing Door Cable AdjustmentsFailure to place vice clamps Onto vertical Track canWinding Bolt Rotation Setting Spring TensionRear Support Drum Wrap InstallationInstallation Instructions Adjustments to the springsParallel with door Or door stop too tightly against faceSide Lock Sold Separately Pull Rope Step Plate Sold SeperatelyTrack radius being used Determine the Wayne-DaltonAppropriate 1/2 1 room permitting above of the high Trolley to operator bracketTrolley Installation for Low Headroom Opens if Photoelectric EYE System Trolley OperatorOperator Rail Suitable mountingCleaning Your Garage Door CleaningPainting Painting MaintenanceLimited Warranty Models 5120