Wayne-Dalton 5120, 5140 Attaching Disconnect Cables, Mounting Disconnect, Handle Bracket

Page 25


24	Attaching Disconnect Cables
Tools Needed:	NOTE: See idrive® main installation and
Pliers	owners manual for idrive® parts.
Pliers
	Attach the loose disconnect cable
	(located in opener hardware bag) to the
	opener with the “S” hook. Close both
	ends of the “S” hook (with pliers) to lock
	assembly together.
	Thread the disconnect cable (behind the
	counterbalance cable) through the hole
	in the right hand end bracket; remove
	all slack between opener and right end
	bracket.

S-Hook

Disconnect

Cable

Hole in Right

End Bracket

Right Side of

End Bracket

Hole in

Close “S” Hook

End Bracket

INSTALLATION

	25	Mounting Disconnect
	25	Handle Bracket
	Tools Needed:	NOTE: See idrive® main installation and
	Pencil	NOTE: See idrive® main installation and
	Pencil	owners manual for idrive® parts.
	Tape measure	Mark a location on the right jamb, 6
	1/8” Drill Bit	Mark a location on the right jamb, 6
	1/8” Drill Bit	feet above the floor to mount the
	7/16” Socket	disconnect handle bracket.
	7/16” Socket
	Driver	Drill 1/8” pilot holes for the lag screws.
	Power Drill	Drill 1/8” pilot holes for the lag screws.
	Power Drill

Align top of the bracket with the mark. Fasten bracket to the jamb with

(2) 1/4” x 1-1/2" lag screws.

6ft

(2) 1/4” x 1-1/2” Lag Screws

	Disconnect
	Handle Bracket
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer.	25

To find your Wayne-Dalton dealer; refer to your local yellow pages / business listings or go to Find a dealer area online at www.wayne-dalton.com

Image 25

Contents 5120 Table of Contents Package Contents Door Section Identification Tools Required For Standard Lift Torsion Spring RemovalFailure to use approved Winding bars can cause Spring energy to be releasedCounter cover when counting Using an electric drill HighBracket will always have a drive gear Head will be pluggedRemoval TorqueMaster SpringRemoving the Old Door Extension Spring RemovalPreparing the Opening Attaching Quick Install Flag InstallationAngle to Vertical Track Horizontal Angle Installing Q.I. Jamb BracketsBottom Section DrumsStacking Sections Vertical TrackBar Top BracketsOperator Bracket Bar AsymmetricalTop Section To the slot in the flagangle using Tools Needed To install horizontal track, placePortion of horizontal track down to Remove the nail that was temporarilyCenter Bracket Bushing TorqueMaster Spring TubePlug the motor power cord into Opener Idrive InstallationGarage looking out Right hand end of the TorqueMasterCable Drum Installation End Brackets Drive Gear InstallationSecuring Center Bracket Assembly Counter InstallationPositioning Support Bracket Mounting Disconnect Attaching Disconnect CablesHandle Bracket Attaching Disconnect Handle Securing Door Cable AdjustmentsFailure to place vice clamps Onto vertical Track canWinding Bolt Rotation Setting Spring TensionRear Support Drum Wrap InstallationInstallation Instructions Adjustments to the springsParallel with door Or door stop too tightly against faceSide Lock Sold Separately Pull Rope Step Plate Sold SeperatelyTrack radius being used Determine the Wayne-DaltonAppropriate 1/2 1 room permitting above of the high Trolley to operator bracketTrolley Installation for Low Headroom Opens if Photoelectric EYE System Trolley OperatorOperator Rail Suitable mountingCleaning Your Garage Door CleaningPainting Painting MaintenanceLimited Warranty Models 5120