Wayne-Dalton 341458 installation instructions Doors, Important Notice

Page 1

9800 doors

TorqueMaster® Plus - Single and Double Spring

Installation Instructions and Owner’s Manual

Wayne-Dalton, a Division of Overhead Door Corporation P.O. Box 67, Mt. Hope, OH 44660 www.Wayne-Dalton.com

IMPORTANT NOTICE!

Read these instructions carefully before attempting installation. If in question about any of the proce- dures, do not perform the work. Instead, have a qualified door agency do the installation or repairs.

©Copyright 2010 Wayne-Dalton, a Division of Overhead Door Corporation

Part No. 341458

REV2 02/26/2010

Image 1
Contents Important Notice DoorsTable of Contents Package Contents Door Section Identification Tools Required For Standard Lift Torsion Spring RemovalFailure to use approved Winding bars can cause Spring energy to be releasedUnwind Springs Removal TorqueMaster SpringBracket and Drive Gear Removing the Old Door Extension Spring RemovalPreparing the Opening Attaching Quick Install Flag Angle to Vertical Track InstallationTools Needed None FlagangleHorizontal Angle Installed as shownTools Needed Place tabs of horizontal angleBrackets Installing Fully Adjustable JambDrums Installing Q.I. Jamb BracketsVertical Track Bottom SectionTop Brackets Stacking SectionsProperly Operator BracketTop Section Attaching Horizontal Track To Quick Install FlagangleDo not Raise Door Until InjurySevere or Fatal Injury Center Bracket Bushing TorqueMaster Spring TubeCable Drums Drum WrapsGarage Looking OUT End Brackets Tools Needed Power Drill Socket Driver Wrench16 18 x 3/4 Securing Center Bracket AssemblyRight End Bracket 16 x 1-5/8Securing Door For Spring Winding Cable AdjustmentRecommended Spring Turns Winding SpringsTools Needed To install drum wraps, position the left Drum Wrap InstallationHand drum wrap over the left hand Raising door further can Rear SupportResult in door falling Otherwise door could fallFull Tension of the Spring Spring Turn ChartCompany Reset the System TorqueMaster Plus Reset InstructionsResetting the ANTI-DROP Device While the Door is MovingBalancing Door Steps to reset the systemPawl TorqueMaster Plus Reset Side Lock Tools Needed Power Drill Drill BitPull Rope Pull Rope Bottom BracketFailure to Make Adjustments Or REPAIRS, if NECESSARY, can Immediate adjustments or repairsInstall operator rail 1/2 to Trolley OperatorGlass Cleaning Instructions Cleaning Your Steel And Fiberglass Garage DoorAcrylic Cleaning Instructions Important do not USE a Pressure Washer on Garage DoorFiberglass Refinishing And Or Finishing Steel Preparation For PaintingLifetime Limited Warranty Model Thank you for your purchase