Wayne-Dalton 341458 installation instructions Table of Contents

Page 2

Table of Contents

 

Important Safety Instructions

2

Package Contents

3

Door Section Identification

4

Tools Required

5

Pre-Installation

5-10

Removing The Old Door

5-9

Preparing The Opening

10

Installation

11-32

Optional Installations

33-34

Side Lock

33

Pull Rope

33

Trolley Operator

34

Maintenance

35-36

Cleaning

35

Painting Instructions

36

Warranty

37

Dealer Locator Information

38

Definition of key words used in this manual:

WARNING

Indicates a potentially hazardous situation which, if not avoided, could result in severe or fatal injury.

CAUTION: PROPERTY DAMAGE OR INJURY CAN RESULT FROM FAILURE TO FOLLOW INSTRUCTIONS.

IMPORTANT: Required step for safe and proper door operation.

NOTE: Information assuring proper installation of the door.

WARNING To AVOID POSSIBLE INJURY, Read these instructions carefully before attempting installation. If in question about any of the procedures, do not perform the work. Instead, have a qualified door agency do the installation or repairs.

1.Read and follow all installation instructions.

2.Wear protective gloves during installation to avoid possible cuts from sharp metal edges.

3.It is always recommended to wear eye protection when using tools, otherwise eye injury could result.

4.Avoid installing your new door on windy days. Door could fall during the installation causing severe or fatal injury.

5.Doors 12’ - 0” wide and over should be installed by two persons, to avoid possible injury.

6.Operate door ONLY when it is properly adjusted and free from obstructions.

7.If a door becomes hard to operate, inoperative or is damaged, immediately have necessary adjustments and/or repairs made by a trained door system technician using proper tools and instructions.

8.DO NOT stand or walk under a moving door, or permit anybody to stand or walk under an electrically operated door.

9.DO NOT place fingers or hands into open section joints when closing a door. Use lift handles/gripping points when operating door manually.

10.DO NOT permit children to operate garage door or door controls. Severe or fatal injury could result, should the child become entrapped between the door and the floor.

11.Due to constant extreme spring tension, DO NOT attempt any adjustment, repair or alteration to any part of the door, especially to springs, spring brackets, bottom corner brackets, red colored fasteners, cables or supports. To avoid possible severe or fatal injury, have any such work performed by a trained door systems technician using proper tools and instructions.

12.On electrically operated doors, pull down ropes must be removed and locks must be removed or made inoperative in the open (unlocked) position.

13.Top section of door may need to be reinforced when attaching an electric opener. Check door and/or opener manufacturer’s instructions.

14.VISUALLY inspect door and hardware monthly for worn and or broken parts. Check to ensure door operates freely.

15.Test electric opener’s safety features monthly, following opener manufacturer’s instructions.

16.NEVER hang tools, bicycles, hoses, clothing or anything else from horizontal tracks. Track systems are not intended or designed to support extra weight.

After installation is complete, fasten this manual near garage door.

2Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your local

yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com

Image 2
Contents Doors Important NoticeTable of Contents Package Contents Door Section Identification Tools Required Failure to use approved Torsion Spring RemovalFor Standard Lift Winding bars can cause Spring energy to be releasedUnwind Springs Bracket and Drive Gear TorqueMaster SpringRemoval Extension Spring Removal Removing the Old DoorPreparing the Opening Tools Needed None InstallationAttaching Quick Install Flag Angle to Vertical Track FlagangleTools Needed Installed as shownHorizontal Angle Place tabs of horizontal angleInstalling Fully Adjustable Jamb BracketsInstalling Q.I. Jamb Brackets DrumsBottom Section Vertical TrackStacking Sections Top BracketsOperator Bracket ProperlyTop Section Do not Raise Door Until To Quick Install FlagangleAttaching Horizontal Track InjurySevere or Fatal Injury TorqueMaster Spring Tube Center Bracket BushingGarage Looking OUT Drum WrapsCable Drums Tools Needed Power Drill Socket Driver Wrench End BracketsRight End Bracket Securing Center Bracket Assembly16 18 x 3/4 16 x 1-5/8Cable Adjustment Securing Door For Spring WindingWinding Springs Recommended Spring TurnsHand drum wrap over the left hand Drum Wrap InstallationTools Needed To install drum wraps, position the left Result in door falling Rear SupportRaising door further can Otherwise door could fallSpring Turn Chart Full Tension of the SpringResetting the ANTI-DROP Device TorqueMaster Plus Reset InstructionsCompany Reset the System While the Door is MovingPawl Steps to reset the systemBalancing Door TorqueMaster Plus Reset Pull Rope Tools Needed Power Drill Drill BitSide Lock Pull Rope Bottom BracketInstall operator rail 1/2 to Immediate adjustments or repairsFailure to Make Adjustments Or REPAIRS, if NECESSARY, can Trolley OperatorAcrylic Cleaning Instructions Cleaning Your Steel And Fiberglass Garage DoorGlass Cleaning Instructions Important do not USE a Pressure Washer on Garage DoorSteel Preparation For Painting Fiberglass Refinishing And Or FinishingLifetime Limited Warranty Model Thank you for your purchase