Door Section Identification

	Door Section Identification

Tools Needed:	NOTE: This provides an alternative
	method for identifying your door
	sections/stacking position.
	Hinges are always pre-attached at
	the top of each section (except top
	section) and the hinges are stamped for
	identification, #1, #2, and #3. See view
	below. The stamp identifies the stacking
	sequence of the section. The sequence
	is always determined by #1 being the
	bottom section to #3 being the highest
	lock/intermediate section. See views to
	the right. If the stamp on the end hinge
	is illegible, refer to the section side view
	illustration to the right.
	The section side view illustration shows
	the end hinge profile of all the sections,
	and can also be used in conjunction
	with identifying each sections.
	The bottom section can be
	identified by #1 end hinges, the factory
	attached bottom astragal, and by the
	bottom bracket warning labels on each
	end stile.
	The lock section can be identified
	by #2 end hinge.
	NOTE: On 3 section high doors, the
	lock section can be identified by
	#3 end hinge and the section will have
	a warning label attached to either the
	right or left hand end stile.
	The intermediate section can be
	identified by #3 end hinges. The section
	will have a warning label attached to
	either the right or left hand end stile.
	The top section can be identified by
	no pre-installed hinges on the section
	and the warning label attached in the

Top Section

#3			Lock Section
#3

Warning label

Top Section

Warning label

Intermediate Section

Lock Section

Bottom Bracket

warning Labels

Astragal Bottom Section

4 SECTION 8’0” high shown above

1 3/8”

1 1/8”

7/8”

center of the section.

Top

int.

Typical hinge stamping location

SECTION side view shown above

4Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your local

yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com