Wayne-Dalton TorqueMaster Plus Reset Instructions and Garage Door Spring Manual

Page 30

TorqueMaster® Plus Reset

Instructions

 

 

 

 

 

Tools Needed:

WARNING

5/8” Socket

To avoid possible injury, READ THESE

INSTRUCTIONS CAREFULLY BEFORE

Ratchet Wrench

ATTEMPTING TO RESET THE TORQUE-

3” Extension

MASTER® PLUS SYSTEM. IF IN QUESTION

ABOUT ANY OF THE PROCEDURES, DO

Vice Clamps

NOT PERFORM THE WORK. INSTEAD,

(Pair)

HAVE A QUALIFIED DOOR INSTALLATION

 

3” Extension

COMPANY RESET THE SYSTEM.

 

 

 

 

 

WARNING

 

ALWAYS KEEP MOVING DOOR IN SIGHT

 

AND KEEP PEOPLE AND OBJECTS AWAY

 

UNTIL IT IS COMPLETELY CLOSED. TO

 

PREVENT A SEVERE OR FATAL INJURY,

 

AVOID STANDING IN A OPEN DOOR WAY

 

OR WALKING THROUGH THE DOORWAY

 

WHILE THE DOOR IS MOVING.

 

 

 

 

WARNING

 

KEEP THE GARAGE DOOR PROPERLY BAL-

 

ANCED. AN IMPROPERLY BALANCED DOOR

 

COULD CAUSE SEVERE OR FATAL INJURY.

 

HAVE A QUALIFIED DOOR INSTALLATION

 

COMPANY MAKE ADJUSTMENTS/REPAIRS

 

TO CABLES, SPRING ASSEMBLIES AND

 

OTHER HARDWARE.

This door is equipped with a Torquemas- ter® Plus system, which provides a safety feature preventing the door from rapidly descending in case of spring failure or forceful manual operation. Typical signs of an engaged system: Door opens, but will not close; door makes a distinct “clicking” noise upon opening. If the system is engaged, carefully follow the reset instructions below in conjunction with the door’s Installation Instructions and Owner’s Manual to reset the Torquemas- ter® Plus system.

Instruction manuals are available for download at www.Wayne-Dalton.com.

RESETTING THE ANTI-DROP DEVICE

1.First, locate and visually inspect the Torquemaster® Plus end brackets to determine if the system has engaged (see illustration on reverse side). NOTE: The Torquemaster® Plus end brackets are located on top of the door on the right and left hand side.

NOTE: If the Torquemaster® Plus system has not engaged, do not complete the following steps.

ENGAGEMENT SIDE VIEW

Ratchet

 

Pawl

 

 

Cable Drum

Drum Pawl

 

 

No space between

ENGAGEMENT Underneath View

drum Pawl and Cable

Drum

 

 

Indicates engagement

No space between

 

drum Pawl and

 

Cable Drum

 

NON-ENGAGEMENT SIDE VIEW

 

Cable Drum

Drum Pawl

 

 

Space between DRUM Pawl

 

and Cable Drum

NON-ENGAGEMENT Underneath View

Non-indicates engagement

Space between

 

drum Pawl and

 

Cable Drum

 

30Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your local

yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com

Image 30
Contents Doors Important NoticeTable of Contents Package Contents Door Section Identification Tools Required Failure to use approved Torsion Spring RemovalFor Standard Lift Winding bars can cause Spring energy to be releasedUnwind Springs TorqueMaster Spring RemovalBracket and Drive Gear Extension Spring Removal Removing the Old DoorPreparing the Opening Tools Needed None InstallationAttaching Quick Install Flag Angle to Vertical Track FlagangleTools Needed Installed as shownHorizontal Angle Place tabs of horizontal angleInstalling Fully Adjustable Jamb BracketsInstalling Q.I. Jamb Brackets DrumsBottom Section Vertical TrackStacking Sections Top BracketsOperator Bracket ProperlyTop Section Do not Raise Door Until To Quick Install FlagangleAttaching Horizontal Track InjurySevere or Fatal Injury TorqueMaster Spring Tube Center Bracket BushingDrum Wraps Cable DrumsGarage Looking OUT Tools Needed Power Drill Socket Driver Wrench End BracketsRight End Bracket Securing Center Bracket Assembly16 18 x 3/4 16 x 1-5/8Cable Adjustment Securing Door For Spring WindingWinding Springs Recommended Spring TurnsDrum Wrap Installation Tools Needed To install drum wraps, position the leftHand drum wrap over the left hand Result in door falling Rear SupportRaising door further can Otherwise door could fallSpring Turn Chart Full Tension of the SpringResetting the ANTI-DROP Device TorqueMaster Plus Reset InstructionsCompany Reset the System While the Door is MovingSteps to reset the system Balancing DoorPawl TorqueMaster Plus Reset Pull Rope Tools Needed Power Drill Drill BitSide Lock Pull Rope Bottom BracketInstall operator rail 1/2 to Immediate adjustments or repairsFailure to Make Adjustments Or REPAIRS, if NECESSARY, can Trolley OperatorAcrylic Cleaning Instructions Cleaning Your Steel And Fiberglass Garage DoorGlass Cleaning Instructions Important do not USE a Pressure Washer on Garage DoorSteel Preparation For Painting Fiberglass Refinishing And Or FinishingLifetime Limited Warranty Model Thank you for your purchase