Wayne-Dalton 341458 Installation, Attaching Quick Install Flag Angle to Vertical Track, Flagangle

Page 11

Installation

IMPORTANT: Read instructions titled “p4” “Removing the old door” on page 9 and “p5” “PREPARING THE OPENING” on page 10 before attempting door installation.

IMPORTANT: Stainless steel or PT2000 coated lag screws MUST be used when installing center bearing brackets, end brackets, jamb brackets, operator mounting/support brackets and disconnect brackets on treated lumber (preservative-treated). Stainless steel lag screws are NOT necessary when installing products on un-treated lumber.

NOTE: It is recommended that 5/16” x 1-5/8” lag screws be pilot drilled using a 3/16” drill bit, and 1/4” x 2” lag screws and 1/4” x 1-1/2” lag screws be pilot drilled using a 1/8” drill bit, prior to fastening.

INSTALLATION

1

Tools Needed:

None

Attaching Quick Install Flag

Angle to Vertical Track

NOTE: If you have fully adjustable flagangle, skip this step and complete Step 2.

Place the lower quick install tab of the flagangle in the quick install feature of the vertical track. Give the flagangle 1/4 turn to lock in place. Repeat for other side.

NOTE: After completing this step, continue with Step 3.

QUICK INSTALL TAB UNLOCKED

QUICK INSTALL TAB LOCKED

FLAGANGLE

FLAGANGLE

VERTICAL	VERTICAL
TRACK	TRACK

Left hand track and flagangle Right hand track and flagangle

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your local 11 yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com

Image 11

Contents Important Notice DoorsTable of Contents Package Contents Door Section Identification Tools Required Winding bars can cause Spring energy to be released Torsion Spring RemovalFor Standard Lift Failure to use approvedUnwind Springs Bracket and Drive Gear TorqueMaster SpringRemoval Removing the Old Door Extension Spring RemovalPreparing the Opening Flagangle InstallationAttaching Quick Install Flag Angle to Vertical Track Tools Needed NonePlace tabs of horizontal angle Installed as shownHorizontal Angle Tools NeededBrackets Installing Fully Adjustable JambDrums Installing Q.I. Jamb BracketsVertical Track Bottom SectionTop Brackets Stacking SectionsProperly Operator BracketTop Section Injury To Quick Install FlagangleAttaching Horizontal Track Do not Raise Door UntilSevere or Fatal Injury Center Bracket Bushing TorqueMaster Spring TubeGarage Looking OUT Drum WrapsCable Drums End Brackets Tools Needed Power Drill Socket Driver Wrench16 x 1-5/8 Securing Center Bracket Assembly16 18 x 3/4 Right End BracketSecuring Door For Spring Winding Cable AdjustmentRecommended Spring Turns Winding SpringsHand drum wrap over the left hand Drum Wrap InstallationTools Needed To install drum wraps, position the left Otherwise door could fall Rear SupportRaising door further can Result in door fallingFull Tension of the Spring Spring Turn ChartWhile the Door is Moving TorqueMaster Plus Reset InstructionsCompany Reset the System Resetting the ANTI-DROP DevicePawl Steps to reset the systemBalancing Door TorqueMaster Plus Reset Pull Rope Bottom Bracket Tools Needed Power Drill Drill BitSide Lock Pull RopeTrolley Operator Immediate adjustments or repairsFailure to Make Adjustments Or REPAIRS, if NECESSARY, can Install operator rail 1/2 toImportant do not USE a Pressure Washer on Garage Door Cleaning Your Steel And Fiberglass Garage DoorGlass Cleaning Instructions Acrylic Cleaning InstructionsFiberglass Refinishing And Or Finishing Steel Preparation For PaintingLifetime Limited Warranty Model Thank you for your purchase