|
|
| el |
13 |
|
| angg |
Attaching Horizontal Track |
| Fla | |
| to Quick Install Flagangle |
|
|
Tools Needed: | NOTE: If you have fully adjustable |
| Key |
9/16” Socket | flagangle, skip this step and complete |
| slot |
|
| ||
Step 14. |
| Horizontal | |
|
| ||
Ratchet Wrench |
|
| track |
9/16” Wrench | To install horizontal track, place the |
| QUICK |
Level | curved end over the top roller. Align |
| INSTALL |
key slot of the horizontal track with the |
| TAB | |
|
| ||
| quick install tab of the flagangle. Push |
| Vertical |
| curved portion of horizontal track down |
| track |
| to lock in place. Level the horizontal |
| el |
| track assembly and bolt the horizontal |
| |
|
| angg | |
| angle to the slot in the flagangle using |
| |
|
|
| |
| (1) 3/8” - 16 x 3/4” truss head bolt |
| Fla |
| and (1) 3/8” - 16 hex nut. Repeat for |
| |
|
|
| |
| other side. Remove the nail that was |
|
|
| temporarily holding the top section in |
| QUICK |
| place, installed in Step 12. |
| |
|
|
| INSTALL |
| IMPORTANT: Failure to remove nail |
| TAB |
|
|
| |
| before attempting to raise door |
| Horizontal |
| could cause permanent damage |
| track |
|
|
| |
| to top section. |
| Key slot |
| WARNING |
| |
|
| track | |
|
|
| Vertical |
| DO NOT RAISE DOOR UNTIL |
|
|
| HORIZONTAL TRACKS ARE SECURED |
|
|
| AT REAR, AS OUTLINED IN Step 26, OR |
|
|
| DOOR COULD FALL FROM OVERHEAD |
|
|
| POSITION CAUSING SEVERE OR FATAL | 3/8” - 16 X 3/4” | 3/8” - 16 Hex nut |
| INJURY. | ||
| TRUSS HEAD BOLT |
| |
|
|
|
NOTE: If an idrive® opener will be installed, position horizontal tracks slightly above level.
Horizontal ANGLE
HORIZONTAL TRACK
INSTALLATION
Please Do Not Return This Product To The Store. Contact your local