Wayne-Dalton 341458 Rear Support, Raising door further can, Result in door falling

26	Rear Support
		DOOR IN THE
Tools Needed:	Raise the door until the top section	UP POSITION
	and half of the next section are in a
Ratchet Wrench	horizontal position. Do not raise door
1/2” Socket	any further since rear of horizontal track
	is not yet supported. Do not space the
1/2” Wrench
	track more than 3/4” from door edge.
(2) Vice Clamps	WARNING
Tape Measure
	Raising door further can
Level
	result in door falling and
Hammer
	cause severe OR FATAL INJURY.				Vice
	WARNING
					clamps
	Keep horizontal track
	parallel and within 3/4”	3/4”
	maximum of door edge,	DOOR EDGE	HORIZONTAL		Vertical
	otherwise door could fall,		TRACK
					TRACK
	resulting in severe OR FATAL
	INJURY.
	Clamp a pair of vice clamps on the
	vertical tracks just above the second
	roller on one side, just below the
	second roller on the other side. This	Weather seal
	will prevent the door from raising
	or lowering while installing the rear	Weather			Weather
	support. Fabricate rear support for
		seal			seal
	horizontal tracks, using perforated
	angle, 5/16” x 1-5/8” hex head lag
	screws and 5/16” bolts with nuts (may
	not be supplied). Attach horizontal	Jamb	Jamb	1/8” to 1/4”
	tracks to the rear supports with 5/16”-	Quick Install Track	Fully adjustable Track
	18 x 1-1/4” hex bolts and nuts (may not	Door			Door
	be supplied). Horizontal tracks must be	stop			stop
	level and parallel with door.	Door			Door
	IMPORTANT: IT IS NOT RECOMMENDED
		Section			Section
	THAT ANY PART OF THE HORIZONTAL	Jamb	Jamb		1/8” to 1/4”
	TRACK HANGER THAT CANTILEVERS 4”
	BEYOND A SOUND FRAMING MEMBERS
	BE USED TO SUPPORT THE WEIGHT OF		PERFORATED
	THE DOOR.		ANGLE
	NOTE: If perforated angle is installed				(3) 5/16”
	over drywall, use 5/16” x 2” hex head				NUTS
	lag screws.
	Adjust weather seal or door stop (if
	necessary) and now permanently attach	(3) 5/16”
	the weather seal or door stop to both
	door jambs and header. (They were	BOLTS
	temporarily attached to the jambs in
	PREPARING The OPENING on page 10.)
	Avoid pushing weather seal or door stop
	too tightly against face of door.

28Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your local

yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com