14 | Attaching Horizontal Track | Flagangle | Stud |
| |||
|
| plate | |
| to Adjustable Flagangle |
| |
|
|
| |
Tools Needed: | NOTE: If quick install flagangles were |
|
|
installed in Step 13, skip this step and |
|
| |
|
|
| |
7/16” Socket | continue with Step 15. If not, complete this |
|
|
step. | 1/4” - 20 |
| |
|
| ||
9/16” Socket | To install horizontal track, place the curved |
| |
flange hex |
| ||
end over the top roller. Align the bottom of |
| ||
| nuts |
| |
Ratchet Wrench | the horizontal track with the vertical track. |
| |
|
| ||
9/16” Wrench | Hand tighten the horizontal track to the |
|
|
flagangle with (1) stud plate and (2) |
|
| |
Level | 1/4” - 20 flange hex nuts. |
|
|
WARNING |
|
| |
Flat Tip |
|
| |
|
|
| |
Screwdriver | DO NOT RAISE DOOR UNTIL HORIZONTAL |
|
|
|
|
| |
| TRACKS ARE SECURED AT REAR, AS | 3/8” - 16 X 3/4” | 3/8” - 16 Hex nut |
| OUTLINED IN STEP 26, OR DOOR COULD | TRUSS HEAD BOLT |
|
| FALL FROM OVERHEAD POSITION CAUSING |
|
|
| SEVERE OR FATAL INJURY. |
|
|
| Level the horizontal track assembly and |
|
|
| bolt the horizontal angle to the slot in the |
|
|
| flagangle using (1) 3/8” - 16 x 3/4” truss |
|
|
| head bolt and (1) 3/8” - 16 hex nut. Repeat |
| Horizontal ANGLE |
| for other side. Remove the nail that was |
| |
|
|
| |
| temporarily holding the top section in |
|
|
| place, installed in Step 12. |
|
|
| IMPORTANT: Failure to remove nail |
| HORIZONTAL |
| before attempting to raise door |
| |
| could cause permanent damage to |
| TRACK |
| top section. |
|
|
| NOTE: If an idrive® opener will be installed, |
|
|
| position horizontal tracks slightly above |
|
|
| level. |
|
|
15 | Adjusting Top Brackets |
|
|
|
|
| |
Tools Needed: | With horizontal tracks installed, you can | Top | Top |
7/16” Wrench | now adjust the top brackets. | section | section |
| |||
|
|
| |
| Vertically align the top section of the |
|
|
| door with the lower sections. Once |
|
|
| aligned, position the top bracket slide, |
|
|
| out against the horizontal track. |
|
|
| Maintaining the slide’s position, tighten | Incorrect | Correct |
|
|
| |
| the (2) 1/4” - 20 flange hex nuts to |
|
|
| secure the top roller slide to the top |
|
|
| bracket base. |
|
|
|
|
| HORIZONTAL |
|
|
| track |
|
| TOP BRACKET |
|
|
| SLIDE |
|
|
| Top | (2) 1/4” - 20 |
|
| FLANGED HEX | |
|
| SECTION | |
|
| NUTS | |
|
|
| |
20 Please Do Not Return This Product To The Store. Contact your local | |||
| yellow pages business listings or go to the Find a Dealer section online at | ||