Wayne-Dalton 341458 installation instructions Stacking Sections, Top Brackets

9

Tools Needed:

Power Drill

7/16” Socket

Driver

Stacking Sections

NOTE: For door section identification see page 4.

NOTE: Make sure hinge leafs are flipped down, when stacking another section on top. Place rollers in hinge tubes of the second section (lock section). With assistance, lift second section and guide rollers into the vertical tracks. Align vertical marks in the upper alignment sticker, with the lower alignment sticker on right hand side on the back of door. Keep sections aligned and fasten hinges to connect the sections using 1/4” - 14 x 5/8” self-tapping screws. Repeat for other section(s) except top section. IMPORTANT: When securing the end hinges to the sections with 1/4” - 14 x 5/8” self-tapping screws, ensure they are attached as shown in the illustrations above.

IMPORTANT: Push & hold the hinge leafs against section while securing with 1/4” - 14 x 5/8” self-tapping screws. End Hinges have (2) screws and Intermediate hinges have (3) screws.

(2) 1/4” - 14 X 5/8”

SELF-TAPPING SCREWS

Alignment stickers

Right end hinge

(2) 1/4” - 14 X 5/8”

SELF-TAPPING SCREWS

Left end hinge

(3) 1/4” - 14 X 5/8”

SELF-TAPPING SCREWS

Intermediate hinge

	(2) 1/4” - 14 X 5/8”
		(3) 1/4” - 14 X 5/8” SELF-TAPPING
	SELF-TAPPING SCREWS	SCREWS
End hinges (left hand shown, right		Intermediate hinges
hinge symmetrically opposite)

10	Top Brackets	2nd set of holes
		from bottom
Tools Needed:	NOTE: For door section identification see	Top section
Power Drill	page 4.
			Endcap
7/16” Socket	To install the L-shaped top brackets,
Driver	align the top holes in the top bracket
	base with the second set of holes from		TOP BRACKET BASE
	bottom of endcap.
	Fasten top bracket base to endcap using	TOP
		SECTION
	(4) 1/4” - 14 x 5/8” self-tapping screws.				(4) 1/4” - 14 x 5/8”
	Secure the top bracket slide to the				SELF TAPPING
	bracket base loosely using (2)		2nd set of		SCREWS
	1/4” - 20 x 5/8” carriage bolts and (2)
			holes from
	1/4” - 20 flanged hex nuts. The bracket		bottom
	will be tightened and adjusted in Step
	15. Insert rollers into top bracket slide.	(2) 1/4” - 20 x 5/8”	TOP BRACKET	TOP	TOP BRACKET
		CARRIAGE BOLTS	SLIDE	SECTION	SLIDE	ROLLER
	Repeat for other side.

(2) 1/4” - 20

FLANGED

HEX NUTS

16Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your local

yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com