A
12" (30.5 cm) Minimum 15" (38.1 cm) Maximum
B
A. Range hood
B. Metal shelf
For best performance, food should be placed directly under the heat lamps, not between them. You may need to adjust your food placement to match your needs.
1.Install heat lamp bulbs into heat lamp sockets.
NOTE: Heat lamp bulbs should be rated to a maximum of 175 watts each. For best performance, 175 watt maximum, PAR38 type, red heat lamp bulbs are recommended. Bulb performance varies. Lower wattage and clear bulbs decrease the performance.
WARNING
Food Poisoning Hazard
Do not let food sit for more than one hour before or after cooking.
Doing so can result in food poisoning or sickness.
2.To turn on the heat lamps, move the switch to the “I” position. To turn off the heat lamps, move the switch to the “O” position.
RANGE HOOD CARE
Cleaning
IMPORTANT: Clean the range hood and grease filters frequently according to the following instructions. Replace grease filters before operating range hood.
2.Repeat for each grease filter.
3.Wash metal grease filters as needed in a dishwasher or hand wash in a hot detergent solution to clean.
To Reinstall Metal Grease Filters:
1.Grasp filter handles and place rear of filter into rear track.
2.Push down on the rear handle and set the front of the grease filter into the front track to secure.
3.Repeat for each filter.
Replacing a Heat Lamp
This range hood uses two 175 watt maximum heat lamps.
Turn off the heat lamps and allow them to cool.
To Replace:
1.Disconnect power.
2.Remove the heat lamp bulb from its socket.
3.Replace the heat lamp bulb with the same type bulb and tighten it in its socket.
4.Repeat steps 2 and 3 with the other heat lamp bulb if necessary.
5.Reconnect the power.
Replacing a Halogen Lamp
Turn off the range hood and allow the halogen lamp to cool. To avoid damage or decreasing the life of the new lamp, do not touch lamp with bare fingers. Replace lamp, using tissue or wearing cotton gloves to handle lamp.
If new lamps do not operate, make sure the lamps are inserted correctly before calling service.
1.Disconnect power.
2.Push up on the lens and turn it counterclockwise.
Exterior Surfaces:
To avoid damage to the exterior surface, do not use steel wool or
Always wipe dry to avoid water marks.
Cleaning Method:
■Liquid detergent soap and water, or
■Wipe with damp soft cloth or nonabrasive sponge, then rinse with clean water and wipe dry.
Metal Grease Filter
To Remove Metal Grease Filters:
1.Use 2 hands to remove the metal grease filters. Grasp filter handles, push toward the rear of the range hood and pull down on the front handle to remove.
3.Remove the lamp and replace it with a
4.Repeat steps
5.Reconnect power.
15