Programming your SmartBake Custom - continued
When programming you can either adapt and customise one of the existing preset menus or you can start from scratch. To customise an existing preset menu, start at step 1 below. To program your own recipe from scratch, press the FAVOURITE button, and start at Step 3 below.
1.Press the FAVOURITE button.
2.To customise an existing menu, select from one of the existing menus from (1) to (8). This will be the basis of your new recipe. Simply press the MENU button to cycle through the menus.
Note: Refer to the Program Setting Times chart on page 64, so you can choose the most appropriate menu.
3.To commence programming press the CUSTOM button for 2 seconds.
The control panel will beep once, custom FAVOURITE will show on the LCD window and the first stage of the breadmaking cycle - Preheat will flash.
4.To adjust times press the buttons. When you have selected the desired time, press the CUSTOM button to move to the next stage of the breadmaking cycle.
Then press the buttons again to select your desired times. Repeat this until all times have been entered. When you have programmed the times for all stages ending in the Keep Warm stage, press the CUSTOM button to finalise your favourite menu.
Note: The process is completed when a longer double beep is heard, FAV will flash on the LCD window and the total breadmaking cycle time is displayed.
5.Once you have finished programming, you can either save your recipe now, by simply pressing the SAVE button, FAV will stop flashing and the control panel will beep 3 times.
Your recipe has now been saved into one of the 8 Favourite Recipe slots.
OR
You can test your recipe first, without yet saving it by simply pressing START. If you then want to save the recipe you must ensure that you press SAVE during but before the end of the KEEP WARM mode.
Note: You can not save the recipe once the Keep Warm cycle is complete.
6.To cancel the programming process at any stage simple press the CANCEL button.
Changing a Favourite Recipe
You can make changes to, or replace any of your saved Favourite Recipes at any time.
1.Select the recipe you wish to modify by pressing the FAVOURITE button. This will allow you to scroll through Favourite Recipes (1) to (8).
2.To commence programming press the CUSTOM button for 2 seconds.
The control panel will beep once and the first stage of the breadmaking cycle - Preheat will flash.
You can now follow the instructions as given in the programming section, steps 3 - 5.
21