DeLonghi A 1346 G Lighting GAS Burners, Fitted with Safety Valve Device and Electronic Ignition

Page 24

LIGHTING GAS BURNERS

FITTED WITH SAFETY VALVE DEVICE AND ELECTRONIC IGNITION

Figure 3.2

Check that the electricity is

switched on to allow spark igni- tion.

Make sure that all controls are turned to zero.

The gas flow to the burner is controlled by taps with safety cutout device. If the burner flame should go out, the safety cut-off valve will automatically stop the gas flow. The switch for the electric ignition is incorporat- ed in the knobs.

You control the flow by turning the knob indicator to line up with the following symbols:

– Symbol

:

tap closed (burner off)

– Symbol

 

:

High (maximum)

– Symbol

 

:

Low (minimum)

To ignite automatically, push the required knob down and turn it to maximum, keeping the knob down until the burner lights. When the flame is lit, wait for about ten second with the knob down (safety cut-off activation delay).

You can control the temperature by the knob to “High” from “minimum”.

To switch off, turn the knob clockwise until you hear the safety click.

Note that, if you are using a burner at the minimum setting, you turn the knob clockwise past the maximum setting before reaching the off position.

Whenever the lighting of the burners is difficult due to peculiar conditions of the gas features or supply, it is advised to repeat the ignition with the knob on “minimum” position.

If when lighting any of the burners an abnormal flame appears, switch the burner off and relight using the minimum setting.

If the flame is still not correct, turn the burner off and call our Customer Service center for your nearest Authorized Delonghi Service Agent.

In the case of a mains failure light the burner with a match or lighted taper.

24

Image 24
Contents 1346 G Dear Customer Product LabelFirst Time USE the Oven Important Precautions and Recommendations 1INSTALLATION Electrical RequirementsConnecting the Feeder Cable Feeder Cable Section type H05RR-FClearances Page Moving the Cooker Backguard ANTI-TILT Bracket GAS Supply Gas connection forPropane GAS Natural GASCooker rear protection Gas pipe Conversion Procedure to convert to LPG Propane Replacing the InjectorsMinimum Burner Setting Adjustment Table for the Choice of the Injectors Lubrication of the GAS TapsUSE and Care Grease Filter TOP Right and Bottom Left Oven onlyPage Page Using the TOP Left Oven for the First Time fig Tilting Grill of the TOP Left Oven fig Control Panel Controls description Pilot lampsGAS Burners Glass Ceramic ZonesFitted with Safety Valve Device and Electronic Ignition Lighting GAS BurnersChoice of Burner Burners Pan diameterGrate for Small Pans Correct USE of TRIPLE-RING BurnerCircuits Radiant Zones Fig Important NoteCooking Hints Type of CookingResidual Heat Indicator Hints for Safe USE of the Hobs Cleaning General Features Operating PrinciplesTemperature Knob Fig Function Selector Knob FigOven Light Traditional Convection CookingUSE of the Grill Oven CookingUpper Heating Element GrillingFAN Oven Bottom left oven Oven Light Defrosting Frozen FoodsHOT AIR Cooking SterilizationRegeneration RoastingOven Cooking Simultaneous Cooking of Different FoodsMultifunction Oven Top right oven Thermostat Fig Grilling Ventilated Grill Cooking Thawing and Warming UPConvection Cooking with Ventilation Simultaneous Cooking of Different Foods Grilling and AU Gratin Electronic Programmer Right main oven only Electronic Clock fig Normal Cooking Without the USE of the ProgrammerElectronic Timer Setting the Frequency of the Audible SignalAutomatic Oven Cooking Semi Automatic Cooking Cooking chart Recommended Cooking TemperatureGeneral Advice Enamelled PartsStainless Steel Surfaces Coated Cleaning the Vitroceramic HOB Stainless Steel Surfaces UncoatedOven Grill Heating ElementBurners Triple Ring BurnerCleaning the Inside of the Ovens Replacing the Oven LightRemoving the Bottom Left Oven Door DrawerRemoving the Oven Doors top left and right ovens Service and Maintenance Wiring Diagram Electric Diagram KEY Rif Cod ß4