CME1356R and CME1656R

Specifications

Both of these ice machines are designed to be installed indoors, in a controlled environment. They can operate satisfactorily under a wide variety of conditions. However, Do NOT operate the machine in temperatures it has not been designed for. Do NOT operate the machine above or below the voltage limits for the particular model. Do NOT operate the machine with too little or too much water pressure.

Operational Limits

	Minimum	Maximum

Air Temperature	50oF.	100oF.
Water Temperature	40oF.	100oF.
Water Pressure	20 psi	80 psi

Voltage (60 Hz)	197	253

Voltage (50 Hz)	207	253

Scotsman reserves the right to make design changes and/or improvements at any time. Specifications and designs are subject to change without notice.

Scotsman assumes no liability or responsibility of any kind for products manufactured by Scotsman that have been altered in any way, including the use of any parts and/or other components not specifically approved by Scotsman.

Bins:

All models will fit a standard, 48" wide or wider open top Scotsman Ice Storage Bin. Some examples are:

BH900

BH1366

BH1666

In addition, there may be other bins that can be used, check Scotsman’s sales literature for application information.

Note: Slope-front bins must have an internal baffle. Scotsman’s BH900 has the required baffle. Baffle must be approximately in the position shown in the diagram below.

Baffle

12.0" 4.0"

Side View

BASIC INFORMATION

Model Number	Dimensions	Basic Electrical	Use	Refrigerant	Minimum	Max
	W x D x H	(volts/Hz/phase)	Condenser	Charge	Circuit	Fuse
	(w/o bin)			R-404A	Ampacity	Size

CME1356RS-32H	48 ½ “ x 24" x 28	208-230/60/1	ECR411-32A	288 oz	24.9	30

CME1356RS-3H	same	208-230/60/3	ECR411-32A	288 oz	15.9	20

CME1356RS-6H	same	230/50/1	ERC411-32A	288 oz	24.9	30

CME1656RS-32H	same	208-230/60/1	ECR411-32A	288 oz	24.9	30

CME1656RS-3H	same	208-230/60/3	ECR411-32A	288 oz	15.9	20

CME1656RS-6H	same	230/50/1	ECR411-32A	288 oz	24.9	30

* The remote condenser is designed to work in temperatures from -20oF. to 120oF.

Use precharged tubing kits, RTE25 (25’) or RTE40 (40’) or RTE75 (75’). Select the length closest to the needs of the particular installation.

The stacking kit required to place two like model cubers together is: KSCME6-LG-B.The kit required to

connect this ice machine to a central condenser is: RCKCME6GX

March 2010

Page 2