Scotsman Ice CME1656R, CME1356R specifications Before Calling for Service, Check the following

Page 45

CME1356R and CME1656R

Before Calling for Service

Check the following:

1.Has the water supply to the ice machine or building been shut off? If yes, the ice machine will automatically restart within 25 minutes after water begins to flow to it.

2.Has power been shut off to the ice machine? If yes, the ice machine will automatically restart when power is restored.

3.Has someone disconnected power to a central condenser (probably on the roof - may be connected to a walk-in cooler). If yes, the ice machine may need to be manually reset.

4.Does the bin control have ice on it? If so, remove the ice and the machine should start in a few minutes.

To Manually Reset the machine.

1.Remove the left front panel.

2.Locate the AutoIQ Controller. If a red

diagnostic light is glowing, note which one and its blink rate. Then push and release the off button.

3.Push and release the Freeze button.

4.The machine should begin to operate. If there is a lack of water it will soon shut off again.

5.Return the front panel to its normal position.

If the machine shuts down again, call for service.

To Shut the Machine Off:

89

7

6

5

4

3

2

1

PUSH BUTTON

CONTROL SWITCHES

INDICATOR LIGHTS:

BIN FULL

FREEZE

HARVEST

CLEAN

OFF

DIAGNOSTIC LIGHTS:

WATER REFRIGERATION

1.Remove the left front panel.

2.Locate the AutoIQ Controller.

3.Push and hold the Off button for 3 seconds or until

March 2003

Page 45

Image 45
Contents CME1356R and CME1656R CME1356R and CME1656R Condenser and Ice Machine Layouts CME1356R and CME1656RSerial Number Plate Pre-InstallationLocation & Assembly Bin Control Installation Mount Bulb Bin ControlStacking Kit KSCME6-LG-B Stacking For The Installer Remote Condenser CME1356R and CME1656R Tighten Swivel Nut Coupling InstructionsHead Pressure Control Add-On Kit Electrical Supply PlumbingDrain Water Filters Follow all applicable codesFinal Check List After Utility ConnectionsComponent Location and Function AutoIQ Controller Initial Start 30 seconds Initial Start UpFreeze Cycle Harvest CycleAdjustments If there was a problem during Initial Start UpHow to Adjust the Amount of Water Purge How To Operate The AutoIQ Controller Refrigeration System How The Electronic Cuber WorksWater System VoltHigh Voltage AutoIQ Controller Operation, Beginning freeze Technicians Only Freeze Cycle SequenceHarvest Technicians Only Harvest Cycle Sequence & Other NotesWater Light Refrigeration LightSanitation and Cleaning Additional Maintenance To Properly Place the Evaporator CoversTo drain reservoir if desired Additional Maintenance Water Distributors Additional Maintenance Inlet Water Valve Screen To Clean the Remote Air Cooled Condenser Additional Maintenance Ice Sensors, CondenserProblem or Symptom Possible Cause Probable Correction Service Diagnosis Diagnostic Light AnalysisService Diagnosis Service Diagnosis Components TXV March Operational Characteristics CME1356R Operational Characteristics CME1656R Removal and Replacement Water Level Sensor/Float Stem Removal and Replacement AutoIQ Controller Removal and Replacement Water Level Sensor Removal and Replacement Refrigerant Liquid Charging Check the following Before Calling for ServiceService Bulletin