![](/images/new-backgrounds/1077317/7731711x1.webp)
IMPORTANT: Because air circulates between both sections, any odors formed in one section will transfer to the other. You must thoroughly clean both sections to eliminate odors. To avoid odor transfer and drying out of food, wrap or cover foods tightly.
Using the Controls
IMPORTANT:
■The refrigerator control adjusts the refrigerator compartment temperature. The freezer control adjusts the freezer compartment temperature.
■Wait 24 hours after you turn on the refrigerator before you put food into it. If you add food before the refrigerator has cooled completely, your food may spoil.
NOTE: Adjusting the refrigerator and freezer controls to a lower (colder) setting will not cool the compartments any faster.
■If the temperature is too warm or too cold in the refrigerator or freezer, first check the air vents to be sure they are not blocked before adjusting the controls.
■The preset settings should be correct for normal household usage. The controls are set correctly when milk or juice is as cold as you like and when ice cream is firm.
■The actual temperature may differ from the display when a door is open for an extended period of time.
NOTE: The factory recommended set points are 0°F
Turning Refrigerator On and Viewing Set Points
■Press and hold POWER (ON/OFF) for 2 seconds.
Viewing the Celsius Temperatures
■Press °C SELECT touch pad. The negative sign
NOTE: If the freezer temperature is below zero, the negative sign next to the freezer display will light up. This is normal.
Adjusting Controls
NOTE: Wait at least 24 hours between adjustments. Recheck the temperatures before other adjustments are made.
To adjust set point temperatures:
■Press the refrigerator or freezer PLUS (+) or MINUS
NOTE: The set point range for the freezer is
CONDITION/REASON: | TEMPERATURE |
| ADJUSTMENT: |
|
|
REFRIGERATOR too cold | REFRIGERATOR Control 1° |
Not set correctly for conditions | higher |
| |
|
|
REFRIGERATOR too warm | REFRIGERATOR Control 1° |
High use or room very warm | lower |
| |
|
|
FREEZER too cold | FREEZER Control 1° higher |
Not set correctly for conditions |
|
|
|
FREEZER too warm/too little | FREEZER Control 1° lower |
ice |
|
High use or heavy ice use |
|
|
|
|
|
Water Filter Status & Reset
Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. Systems certified for cyst reduction may be used on disinfected waters that may contain filterable cysts.
The water filter display will help you know when it is time to change your filter. To change the filter, see the “Water Filtration System” section.
INDICATOR: | STATUS: |
|
|
99 percent | New filter installed |
|
|
10 percent | Order replacement filter |
|
|
0 percent or flow decreases | Replace filter |
|
|
■After replacing the water filter, press RESET and hold for
2 seconds to change the water filter display to 99 percent.
Holiday Feature
The Holiday feature is designed for the traveler or for those whose religious observances require turning off the lights and ice maker. By selecting this feature, the temperature set points remain unchanged, the ice maker will be disabled and the interior lights will turn off. For most efficient refrigerator operation, it is recommended to exit the Holiday feature when it is no longer required.
■Press HOLIDAY to turn on the Holiday feature. This feature will remain on until the Holiday key is pressed again.
6