S U R FA C E C O N T RO L S C O O K I N G
SETTING SURFACE CONTROLS
Use to operate the surface elements. The control knobs can be set anywhere between HI and LO.
Place pan on surface element. | There are element indicator lights above the each | |||
Push in and turn the knob in either direction to the | knob on the control panel. When any control knob | |||
is turned on, the light will glow. |
| |||
desired heat setting. |
| |||
|
|
|
| |
NOTE: | OFF |
|
| ON |
The Control Panel is marked |
|
| ||
to identify where the |
|
|
|
|
element is. | After cooking, turn knob to OFF |
|
ENGLISH
HOT SURFACE INDICATOR
A Hot Surface indicator light will glow when the surface is too hot to touch because of the heating element. It will remain on after the element is turned off and the surface has cooled to approximately 150 deg F.
CAUTION
•DO NOT touch surface elements until it has cooled down sufficiently.
-The surface elements may still be hot and burns may occur.
USING THE ELEMENT
To turn on a SINGLE surface unit:
(Left Rear, Right Rear)
Push the knob in.
Turn the knob in either direction to the setting you want.
The control knob clicks when it Is positioned at both OFF and HI.
22
1
CAUTION
•NEVER leave food unattended at high or medium- high setting.
-Boil overs can cause smoke. Greasy spillovers may catch on fire.
To turn on a DUAL surface unit: (Left Front)
There is one dual element located in the left front position. This allows you to change the size of element.
Push the knob in.
Turn the knob counterclockwise to the
SINGLE surface unit settings.
Turn the knob clockwise to the DUAL surface unit settings
e | Dual |
Singl |
|
22
AB
1
Heating with inner | Heating with both |
(smaller)element only | elements together |
AB
11