Pitco Frialator 60149518, 60149517 manual Other Displays

Page 38

Solstice I12+ Cooking Computer for ROV Fryers

Pitco P/N 60149517 & 60149518

11Other Displays:

Open probe detection is standard on all Pitco controls. If probe is detected open, normal heating and cooking activities are suspended.

This display warns operators that the vat temperature has exceeded set temperature by +40°F (+22°C), or an absolute maximum of 410°F (210°C). The alarm will also sound. This display does not show the status of the mechanical high limit switch.

This message indicates that the drain valve has been opened, the vat is assumed to be empty by the controller. Normal heat control activities are suspended. Display will show an alternating message [DRAINING] [TURN OFF]. To restore to normal operation, close the drain value. Display will show [TURN OFF] [TURN OFF].

Turn controller off, and refill the vat. Continue with normal operations at section 1.

This message indicates that the heating system failed to respond. Typically, the high temperature limit switch has tripped and is in need of resetting. In the case on gas fired appliances, this message will display if the pilot fails to light or is detected marginal by the ignition module.

This message indicates a shorted probe. If probe is detected as a short circuit, normal heating and cooking activities are suspended.

This message indicates the computer has lost communication with the autofilter control board and oil management operations are suspended. Normal cooking activities are unaffected.

L22-378 Rev 3

Page 38 of 44

Image 38

Contents For Pitco P/N’s 60149517 Full Vat and 60149518 Split Vat Important Information for Future ReferenceFahrenheit or Celsius Display To Enter Programming Level 3 for the Technician To Exit Programming Level 5 To turn the appliance OFF Key Locations and FunctionsTo turn the appliance on To start a cook To cancel a cookTo check Actual and Set temperatures Manual Boil Entry Perform a Boil Out operationAutomatic Boil Entry Water Detection Filter Control Option Oil Handling and Fryer Operations Fresh Oil Top-OffManual Filtering FDF Triggering Option Automated Filtering OptionAutomatic Filtering Automatic PolishingAdvanced Fryer Operations For Automated Filtering Option Automatic DisposalBlocked Drain Full Vat/Left Return Pump Full Vat/Left Drain ValveRight Drain Valve Split Vat Only Full Vat/Left Manual Top-OffRight Return Pump Split Vat Only Filter Soon Right Manual Top-Off Split Vat OnlyControl Filter Lockout CFL Filter NowJIB Oil Remaining JIB Check/ErrorFresh Oil Supply Monitoring Data Logging Using the product keys as a numeric keypad forFilter Data Function FDF Data Logging Data ViewingPage Cook Time To Set Cook TemperatureTo Enter Programming Level 1 for the Store Manager Hold Time Hold Pre-AlarmShake Time To Exit Level 1 programmingFahrenheit or Celsius Display Password Change or RequiredTo Change Options Level 2 for the Store Manager Melt Cycle Type Beeper Volume and ToneLanguage Selection Control or Timer Right side of Dual Vat Recovery Test ValueControl or Timer Left side of Dual or Single Vat Melt Cycle on Time Offset the Temperature DisplayTo Enter Programming Level 3 for the Technician Minimum on and OFF Cycle TimeRecovery Times Ready Level Diagnostic Menu EntryExit Diagnostic Menu Instant On Toggle Temperature Operating RangeMore Service Menu Entry Cook NowCancel Duration Shake Alarm DurationHold Alarm Duration Configuration ValueStanding Pilot Toggle Factory ResetExit More Service sub menu Flex Time ToggleFull Vat Fryer Basket n SettingNumber of Basket Lifts Split Vat Fryer LBASKETnTo Enter Factory Menu Level 4 for the Technician Offset Temperature DisplayRecovery Test Values Pitco Collect toggleTest On/Off High Limit ValueNumber of Basket Lift To Exit Factory Menu LevelFilter Time To Enter Filter Settings Menu Level 5 for the Store ManagerDrain Time Fill Time Filter TemperaturePolish Time Cook Counts Deferred Oil Level Probe/Auto Top-Off EnableCook Counts Allowed Auto Top-Off Time Filter Data Function Enable JIB Monitor Oil Remaining Enable More Filter Menu EntryMaximum JIB Time JIB Monitor Check/Fault EnableFilter Return Key Enable Low JIB TimeOn-Demand Top-Off Key Enable To Exit More Filter MenuOther Displays Mechanical Dimensions Electrical Connections at Left and Right connectors J1Left Inputs Type NominalOhms Probe Resistance ChartProbe Resistance in 5F Increments Probe ResistancePage Page L22-378 Rev