GE JBP80 Step Wire System Special Grounding Instructions, Disconnect the link from neutral

Page 51

2. Aluminum Wiring

A.Connect length of copper building wire to range terminal block.

J3. Splice copper wires to aluminum wiring using special connectors designed and U.L. approved for joining copper to aluminum, and follow the connector manufacturer’s recommended procedure closely.

NOTE: Wire used, location and enclosure of splices, etc., must conform to good wiring practice and local codes.

STEP 5

4-WIRE SYSTEM

SPECIAL GROUNDING INSTRUCTIONS

WARNING:

Frame grounded to neutral of appliance through a link. If used in a MOBILE HOME or if LOCAL CODES do not permit grounding through the neutral: -

1)disconnect the link from neutral,

2)use grounding terminal or lead to ground unit in accordance with local codes, and

3)connect neutral terminal or lead to branch circuit in usual manner.

(If the appliance is to be connected by means of a cord set, use 4-conductor cord for this purpose. ),, ,, ,,

CONNECTOR

BLOCK

4TH GROUNDING LEAD ~ u

GROUND

LUG

STEP b

ANTI-TIP BRACKET INSTALLATION

AN ANTI-TIP bracket is supplied with instructions for installation in a variety of locations. The instructions include a template, a parts list and a list of tools necessary to complete the installation. Read the IMPORTANT SAFETY INSTRUCTIONS ancl the instructions that fit your situation before beginning installation.

WARNING

1.Range must be secured by ANTI-TIP bracket supplied.

2.See instructions to install (supplied with bracket).

3.Unless properly installed, range could be

tipped by stepping or sitting on door. Injury might result from spilled hot liquids or from the range itself.

Typical installation of Anti-Tip bracket

Attachment to Wall

Bracket

 

Screw Must Enter \

I , Wall Plate

STEP 7

LEVELING THE RANGE

The range must be level. Leveling feet are located at each corner of the base of the range. Remove the storage drawer or kick panel (depending on your model) and using channel locks, rotate the leveling feet in and out as required to level the range. (For instructions on how to remove and replace the storage drawer or the kick panel, see the Cleaning Under the Range section in Care and Cleaning.) On some models, there are plastic covers which may be removed for easy adjustment (just squeeze and pull).

One of the rear leveling feet will engage the ANTI-TIP bracket (allow for some side to side adjustment). Allow a minimum clearance of 1/8” between the range and the leveling foot that is to be installed into the ANTI-TIP bracket.

Check the range for proper installation into the ANTI-TIP bracket (after the range has been properly installed) by removing the kick panel or storage drawer and inspecting the rear leveling leg. Make sure it fits securely into the slot.

STEP 8

FINAL CHECK

Be sure all switches are in the OFF position before leaving the range.

51

Page 50 Page 52
Image 51
Page 50 Page 52
Contents Iiill Page If you received a Damaged range If YOU Need ServiceSave time and money. Before you request service Write down the model and serial numbersAWARNING- s Self-Cleaning Oven OvenKeep the oven vent duct unobstructed Surface Cooking Units Important Safety InstructionsSave These Instructions Halogen/Radiant Surface UnitsSurface unit. The use of undersized cookware Features of Your Range Not all features are on all models. Appearance may varyJBP95 40,41,45 HOW does this Cooktop Compare To Your OLD ONE? Differences Between Halogen and Radiant Units General Information About Halogen/Radiant Surface UnitsHome Canning Tips Observe the Following Points in CanningGlass Cooktop Cautions Special Notes for Glass Cooktops How to Set the ControlsCooking Guide for Using Heat Settings Light Over the Surface UnitsSurface Cookware Tips Dual Surface Unit Switch Glass Cooktops OnlyHot Surface Indicator Light Glass Cooktops only Surface ControlsPorcelain/enamel Wok Cooking~pes of Cookware Do not use woks that haveHow to Check Pan Performance Glass Ceramic Cooktop Cleaning On some modelsFor heavy, burned on soil Stop Clock Time Features of Your Oven ControlBake CO NV Broil LO~ RoastPower Outage TimerTo Set the Timer To Reset the TimerOven CONTROL, Clock and Timer Child Lockout FeatureIncrease and Decrease Pad Speed Offset Shelf Before Using Your OvenLight comes on automatically when the oven door is opened Oven LightUsing Your Oven Oven ShelvesShelf Positions What is Convection? When should you use Convection Bake or Convection Roast?Cookware for Convection Cooking Multi-Shelf Baking When baking on 3 shelves, divide the oven intoConvection Baking Adapting Recipes For Convection BakingHow to Convection Time Bake Cleaning onlyBaking Stop How to Set Delay Start and Automatic Stop Convection BakeCO NV Cook TimeAdapting Recipes for Convection Roasting Convection Roasting RackPost CO NV Roast Convection RoastingHow to Set Your Oven for Baking Regular BakingIibake Type of Food Shelf Position Pan PlacementPreheating Baking PansCakes Fiaking GuidesCookies PiesHow to Time Bake How to Set Immediate Start and Automatic StopRegular Timed Baking Adjust the Oven THERMOSTAT-DO IT Yourself How to Set Delay Start and Automatic StopTo Adjust the Thermostat Clear OFF Bake Use of Aluminum FoilSee the Regular Roasting Guide Correct Placement of the Temperature ProbeRegular Roasting with the Probe Ham or Lamb Casseroles or FishProbe How to Set the Oven When Using the Temperature ProbeQuestions and Answers Roasting GuideFrozen Roasts Immediately, and leave the pan Meal for easiest cleaningBroiling CLEAR/OFF-pad. Serve the foodShould I salt the meat before broiling? Why are my meats not turning out as brown as they should?Broiling Guide Ground BeefChicken Before a Clean Cycle To Stop a Clean Cycle Operating the SELF-CLEANING OvenHow to Set the Oven for Cleaning After a Clean CycleWhy do I have ash left in my oven after cleaning? How to Delay Start of CleaningShould there be anv odor during the cleaning? My oven shelves do not slide easily What is the matter?Sure Grip Handle Care and CleaningControl Panel and Knobs Cooktop Surface LightLift-Off Oven Door Oven Light ReplacementDo not store a soiled broiler pan and grid anywhere ProbeBroiler Pan and Grid Oven Shelves and Convection Roasting RackOven Heating Elements Metal PartsPainted Surfaces Glass WindowTo replace a surface unit Clean the area under the drip pans oftenSurface Unitsmrip Pans Electric Coil Models To remove a surface unitPl+30 ‘- ‘Q=m -- MIN Nyie lhis appliance must be properly groundedInstallation Instructions Range to be moved for cleaning or servicingCopper Wiring Disconnect the link from neutral Step Wire System Special Grounding InstructionsQUESTIONS? USE this Problem Solver Glass Cooktop Models Management to perform this check before calling for serviceKnob is set for the surface unit you are using Electric Coil ModelsProblem Solver Al-’ I’’eptt’1 Wdll Be ThereWarranty
Top Page Image Contents