HEAVY DUTY COUNTERLINE | ADJUSTMENTS |
ADJUSTMENT OF PILOT FLAME (GRIDDLE MODELS)
The pilots are adjusted at the factory. If later the pilots are
1.Open the door on the lower front of the appliance, remove the control knobs, and remove the control panel by removing the screws holding it in place.
2.If necessary, light the pilots.
3.Locate the adjustment valve of the pilot that needs adjustment (see Figure 16 below). On thermostatic griddles, the valve is in the pilot’s supply line, while on manual griddles the valve connects the pilot’s supply line to the front manifold. Turn the pilot adjustment screw to the left to increase the size of the pilot flame, or to the right to decrease the size of the pilot flame. The flame should be about 1/2" high with a slight yellow tip, and cover the thermocouple tip. The flame is too high if the yellow tip is producing black streaks of carbon.
4.Repeat Step 3 for each pilot.
5.Replace the control panel and knobs.
Figure 16 |
Pilot Flame Adjustment Screw |
on Thermostatic Griddles |
Pilot Flame Adjustment Screw |
on Manual Griddles |
ADJUSTMENT OF PILOT FLAME (CHARBROILER AND OPEN-TOP MODELS)
The pilots are adjusted at the factory. If later the pilots are
1.If necessary, light the pilots.
2.Locate the pilot adjustment valve (see Figure 17 below). Turn the pilot adjustment screw to the left to increase the size of the pilot flame, or to the right to decrease the size of the pilot flame. The flame should be about 1/2" high with a slight yellow tip. The maximum pilot flame height is 3/4". The flame is too high if the yellow tip is producing black streaks of carbon.
4.Repeat Step 3 for each pilot.
5.Replace the control panel and knobs.
Figure 17 |
|
Pilot Flame |
|
Adjustment Screws |
|
OWNER’S MANUAL 1182845 REV 8 | PAGE 29 |
ADJUSTMENTS