Description of parts:
FIG. 01
1
2 Hot water/brew switch (pump)
3 Temperature
4 Steam switch (temperature)
5 Drip plate
6 Removable water tank
7 Steam/hot water knob
8 Steam pipe
9 Filterholder
10 1 cup filter (or coffee pod)
11 2 cup filter
12 Drip tray
13 “Perfect crema” device
14 Brewing head
15 Filterholder gasket
16 Shower disc
17 Tamper
18 Power cable and plug
19 Measuring spoon
Instructions for the power supply cord
AA short
B Longer extension cords are available and may
be used if care is exercised in their use. C If a long extension cord is used:
1 the marked electrical rating of the extension cord should be at least as great as the electrical rating of the appliance.
2 if the appliance is of the grounded type, the extension cord should be a grounding type
3 the cable does not hang from the table to avoid the risk of getting caught up in it.
ENGLISH
Preparation:
1.Remove the water tank (6) and fill with cold water. See FIG. 02.
IMPORTANT: Once the tank has been reinserted, ensure that the silicon pipes are inside the actual tank and not tangled or blocked.
2.Insert plug (18) into a suitable wall outlet (see point 1 under “Caution”).
3.Turn the power switch (1) to “1”. The power- on indicator light will light up.
Make certain that the hot water/coffee switch
(2)and that the steam switch (4) are in the “0” position.
Starting up
This procedure fills the water boiler with fresh water.
This should be done whenever the machine is switched on.
This machine, featuring a pump to brew coffee, is equipped with a
You will hear the sound of the operating pump and after few seconds, water will start to escape from the brewing head (14).
• 9 •