McCulloch MRT6 Ground drive belt replacement, Tine replacement, Inches Counter tine Rotation

5

1. New tine

2.Worn tine

3.Sharp edge

4.Hairpin clip

5.Retaining pin

Figure 16

12

Figure 17

tine_3

Tine Tine

3-1/2 Inches

Figure 18

	4	Counter tine
3		rotation
		4
		3
5	3
	5	3

Ground drive belt replacement

Take to an authorized dealer for repair.

Tine replacement

A badly worn tine causes your tiller to work harder and dig shallower. Most important, worn tines can not chop and shred organic matter as effectively nor bury it as deeply as good tines. A tine this worn (fig. 16) needs to be replaced.

To maintain the superb tilling performance fo this machine the tines should be checked for sharpness, wear and bending, particulary the tines which are next to the transmission (fig. 17). If the gap between the tines exceeds 3-1/2", they should be replaced or straightened as necessary.

New tines should be assembled as shown in (fig.18.) Sharp- ened tine edges will rotate rearward from above (fig.18).

CAUTION!

Never tamper with the engine governor, which is factory set for proper engine speed.

49