Assembly Instructions
Attach Spring
Roller
Wheels
Installation on Rear Discharge Deck
Mower Deck Installation on Tractor
Deck Installation
1.Lightly grease each deck support arm (2) on the tractor. Refer to Mower Deck Installation photo for location of deck support arm.
2.Engage the deck carrier frame tube sockets on the tractor support arms (refer to Discharge
Chute and PTO Shaft Guard Installation photo for socket location), slide the deck onto the support arms approximately 3 in. (76 mm).
3.Retract the
NOTE: The Coupler Installation Tool is provided for convenience, but is not required for installation.
Coupler
Installation Tool
PTO Coupler
TubeRetract
Quick Disconnect Ring
PTO Coupler Installation Tool
4.Reaching under the tractor, slide the PTO cou- pler tube onto the deck drive shaft (align arrow decals), then install the coupler quick discon- nect onto the tractor PTO drive shaft.
NOTE: When installing the DS52 or DS62 Mower deck, make sure to retract the dolly wheel after mounting the deck on the tractor.
Arrows on Shaft and Tube |
(Used to Align When Sliding Together) |
PTO |
Connection |
Grease Deck |
Support Arms |
Mower Deck Installation
(PTO Shaft Connection)
5.Remove Installation Tool from quick disconnect ring and make sure the ring has “snapped” securely on the spline shaft.
IMPORTANT: DO NOT operate tractor with Coupler Installation Tool installed.
IMPORTANT: To prevent damage to the mow- er, make sure the PTO quick disconnect is se- curely locked on the tractor, with the locking balls fully seated in the groove and the ring in the locked position (refer to the Quick Disconnect Ring “Locked” Position illustration). After in- stallation, pull on the PTO coupler to check for security.
21