Walker MC19 manual Quick Disconnect Ring Released Position, Quick Disconnect Ring Locked Position

Assembly Instructions

Coupler Ring in	PTO Drive
Released Position	Shaft
PTO Coupler
U-Joint

Quick Disconnect Ring “Released” Position

Internal Balls		PTO Drive
Locked on Shaft		Shaft
PTO Coupler	Coupler Ring in
U-Joint	Locked Position

Quick Disconnect Ring “Locked” Position

6.Slide the deck the rest of the way on the deck arms. If the deck is rear discharge (GHS equipped model), the rear discharge chute will need to be aligned and connected to the blower inlet during the last 2 in. (51 mm) of slide action on the support arms.

NOTE: Raising the mower body may be helpful in fitting and guiding the deck chute into the blower.

7.Install the hitch pin through the hole on the end of each support arm to lock the deck in place (refer to Deck Counterweight Spring Installa- tion photo). Two (2) hitch pins are included in the Owner’s Packet of materials.

8.Raise the mower body (instead of lifting the front of deck) and clip the counterweight springs to the receptacle on front of body. Lower the body to tension the springs. (Refer to Deck Counterweight Spring Installation photo.)

9.With the counterweight springs connected, the weight on the deck caster wheels should be 15 to 25 Ib (6.8 to 11.3 kg); this adjustment is preset at the factory. If required, the spring ten- sion can be adjusted by tightening or loosening the elastic stop nuts located underneath the lower spring hook, or contact your local dealer if additional help is required. Refer to Deck Counterweight Spring Installation photo.

Spring Tension Adjustment

Nut Located Under Lower

Spring Hook (Not Visible)

Counterweight Springs
	Hitch Pins
Clip Onto Body With	Lock Deck On
Forward Body Tilted Up	Support Arms

Deck Counterweight Spring Installation

22