Woods Equipment BW240HDQ manual Install Spring Wheel Arms, Install Tongue

Install Spring Wheel Arms

1.Slide right spring wheel arm assembly (14) over center wheel yoke tube and secure into position using four cap screw (28) and flanged lock nut (37). Repeat step to install left spring wheel arm assembly. Keep spacing as wide as possible for greater stability.

2.Attach wheels to hubs using five lug nuts. Install the chamfered side of the lug nut toward the inside for steel rim for pneumatic tires and rims. Tighten to 75 lbs-ft. Check that tire air pressure is a maximum of 40 psi.

NOTE: Install the flat side of the nut toward the inside for solid tires and aircraft tires (shown).

NOTE: Pneumatic, notat, and airplane tires are available for this cutter. See page 61 for parts list.

14. Spring wheel arm assembly

28. 3/4 NC x 6 HHCS GR5

37. 3/4 NC Flange lock nut

Figure 24. Right Spring Wheel Arm Installation

Install Tongue

1.Attach tongue (22) to center section using two tongue pivot pins (31). Secure pivot pins to mast plates using carriage bolts (67) and lock nuts (53).

NOTE: Attach hose holder (25) to right mast plate with hardware shown.

2.Attach both attitude rods (4) to lower holes on tongue and secure with clevis pin (32), washer (33), and cotter pin (63).

3.Attach parking jack (20) to the side of the tongue.

4.Attitude rod

20.Parking jack

22.Tongue

25. Hydraulic hose holder

31.Tongue pivot pin

32.Clevis pin, 1" x 2.26"

33.Washer, flat 1"

53. 1/2 NC Flange lock nut

63. Cotter pin, 1/4" x 1-1/2"

67. 1/2 NC x 2 Carriage bolt

Figure 25. Tongue Installation

MAN0763 (10/10/2008) Assembly 35