Install Wing Wheel Yoke Adjustment Link
CAUTION
Use a suitable lifting device of sufficient capac- ity. Use adequate personnel to handle heavy com- ponents.
1.With a lifting device raise right wing and lock in the up position using the wing
2.Attach adjustable link (turnbuckle, 22) to right side of center wheel yoke arm and secure with cap screw (32) and lock nut (26).
3.Attach opposite end of adjustable link (22) to wing wheel yoke arm and secure with cap screw (32) and lock nut (26).
4.Remove
5.Repeat process for left wing.
6.See Cutting Height (Normal Mowing) - Wings, page 16 to level wings.
32
22
26 |
22. Adjustable link
26. 1 NC Lock nut
DP6 | 32. 1 NC x 4 HHCS GR8 |
Figure 31. Right Wing Wheel Yoke
Adjustment Link Installed
Install Wing Driveline
1.Remove knob on top of clutch shield (3) and raise shield.
2.Slide clutch of driveline (4) over wing gearbox shaft and align holes with groove.
3.Secure driveline to shaft using cap screws and lock nuts supplied with driveline.
4.Slide opposite end of driveline over splitter gearbox and secure using cap screws and lock nuts supplied with driveline.
5.Repeat process for left driveline.
3.Clutch shield
4.Wing driveline, complete
Figure 32. Right Driveline Installation
FILL GEARBOXES
1.Remove top and side plugs from gearbox.
2.Fill gearbox with SAE 80W or 90W EP oil until it runs out of side level hole. Install plug in the side hole and vented dipstick in the top.
3.Allow oil to drain into the lower bearings and recheck oil level.
4.Fill all gearboxes.
5.Attach hose to each elbow.
MAN0763 (10/10/2008) | Assembly 39 |
|
|