Multiquip DCA180SSJU operation manual Shut Down Codes, Damage, Backlight Adjustment

Page 27

DIAGNOSTIC DISPLAY

Shut Down Codes

1.During normal operation the single or four parameter screen will be displayed.

5.Touching the “Enter Button” once again will hide the fault and return the screen to the single or four parameter display.

1 of x SHUTDOWN

						98%
						98%
0				3000		LOAD RPM
0	1500			3000		LOAD RPM
	1800 RPM
	1800 RPM					14.2
						14.2
ENG RPM		COOL TEMP				BATT VOLT
ENG RPM		COOL TEMP

1000 RPM	SPN110 FMI10
ENG RPM	HIGH COOLANT TEMP
	HIGH COOLANT TEMP
	MORE	HIDE
57 PSI
OIL PRES

	2. When the diagnostic display receives a severe fault code	6. The Single or Four parameter screen will display the
	from an engine control unit the single or four parameter	fault icon until the fault condition is corrected. NOTE:
	from an engine control unit the single or four parameter	Ignoring active fault codes could result in severe engine
	screen will be replaced with the “Shutdown” message.	Ignoring active fault codes could result in severe engine
	screen will be replaced with the “Shutdown” message.	damage.
		damage.

1 of x SHUTDOWN

SPN110 FMI10

HIGH COOLANT TEMP

MORE HIDE

					!	98%			1000 RPM
					!	98%			1000 RPM
0	1500			3000		LOAD RPM			ENG RPM
	1800 RPM							!
	1800 RPM							!
		COOL TEMP!				14.2			57 PSI
ENG RPM		COOL TEMP!				BATT VOLT			OIL PRES		!
											!

3.To acknowledge and “Hide” the fault and return to the single or four parameter display touch the “Enter Button”.

1 of x SHUTDOWN

SPN110 FMI10

HIGH COOLANT TEMP

MORE HIDE

4.The display will return to the single or four parameter display, but the display will contain the “Shut Down” icon. Touching the “Enter Button” will redisplay the hidden fault.

					!	98%			1000 RPM

0	1500			3000		LOAD RPM			ENG RPM
	1800 RPM							!

		COOL TEMP!				14.2			57 PSI
ENG RPM						BATT VOLT			OIL PRES

Backlight Adjustment

1.Starting at the single or four engine parameter display touch the “Menu Button”.

						98%		1000 RPM


0				3000		LOAD RPM		ENG RPM
0	1500			3000		LOAD RPM		ENG RPM
	1800 RPM
	1800 RPM
						14.2		57 PSI
ENG RPM		COOL TEMP				BATT VOLT		OIL PRES
ENG RPM		COOL TEMP

2.The main menu will pop up on the display. Use the “Arrow Buttons” to scroll through the menu until the “Adjust Backlight” is highlighted.

GO TO 1-UP DISPLAY

STORED CODES

ENGINE CONFG

SETUP 1-UP DISPLAY

SETUP-4-UP DISPLAY

SELECT UNITS

ADJUST BACKLIGHT

DCA-180SSJU — OPERATION AND PARTS MANUAL — REV. #3 (02/01/10) — PAGE 27

Image 27

Contents Model DCA180SSJU 60HZ Generator Parts List NO. M3870301004Proposition 65 Warning Nhtsa Reporting Safety DefectsTable of Contents MQ Power DCA-180SSJU Whisperwatttm GeneratorOrdering parts has never been easier Parts Ordering ProceduresGenerator Specifications SpecificationsDimensions Dimensions TOP, Side and FrontSafety Message Alert Symbols Conjunction with SafetyPotential hazards associated with the operation of this Always wear approved protection ProtectionThis generator, other property Drugs or alcohol General SafetyResult causing severe Rules for Safe OperationGenerator Grounding Electrical SafetyAvoid eye irritation Maintenance SafetyBattery Safety Use the following guidelines when handling the batteryTowing & Transporting Safety DOTEmergencies Generator Decals Generator DecalsGenerator Decals Cont inued Typical Generator Grounding Application InstallationMounting Outdoor InstallationIndoor Installation When connecting the generatorGeneral Information Generator Major Components Major ComponentsDiagnostic Display Menu Button Press this button to enter or exit menu screensDisplay Parameters Main Menu Navigation Engine. Note Displays only when SAE J1939First Time Start Up Next item downTo make a selection Diagnostic CodeStored Fault Codes Engine Configuration DataDiagnostic Display 24 DCA-180SSJU Operation and Parts Manual REV. #3 02/01/10 Auxiliary Gage Fault Active Fault Codes Backlight Adjustment Shut Down CodesDamage Contrast Adjustment IntensityContrast is highlighted Select Units Setup 1- Up DisplayUp display function Once the Setup 1-up Display menu icon has beenAutomatic Scan on Setup 4-Up Display Select the 4-Up Custom Setup from the 4-Up Setup menuTouch the Enter Button and a list of parameters will appear Utilities Engine OIL Temperature34 DCA-180SSJU Operation and Parts Manual REV. #3 02/01/10 Touch the Menu button again to return to the Main MenuTouch the Menu Button Highlight it, then touch Enter Press and hold the Menu button for approximately 3 seconds Glossary Troubleshooting informationECU did not respond to the PowerView request No parameter selected for this 4- UP quadrantCircuit breaker Position on To restore power toGenerator Control Panel Button on the overcurrent relay and placeFuel Gauge Indicates amount of diesel fuel available Engine Operating PanelUnit. This is considered a FaultAuto On/Off Engine Controller Mpec Engine by initializingOutput Terminal Panel Familiarization Are consideredOutput Terminal Familiarization Counter-clockwise will Voltage Removing the Plastic Face Plate Hard Wire Hookup PanelVAC Gfci Receptacles PressingOver Current Relay Connecting LoadsLoad Application Single Phase LoadThree Phase Load System, amust install anMaximum Amps Generator OutputsGenerator Output Voltages Voltage Change-Over BoardAre Generator OUTPUTS/ Gauge ReadingAC Ammeter Gauge Reading Show a reading when1Ø-240V Uvwo Terminal Output Voltages Output Terminal Panel ConnectionsUvwo Terminal Output Voltages 3Ø-240V Uvwo Terminal Output VoltagesUwvo Output Terminal Lugs 1Ø-277V Connections 3Ø-480 Uvwo Output Terminal VoltagesFuel Check SetupCircuit Breakers Lubrication OilRefueling Procedure ONLY! useRefueling Operation Freezing Weather Cleaning the RadiatorAir Cleaner Fan Belt Tension Coolant AntifreezeAlternator BatteryBattery Cable Installation WiringGenerator START-UP Procedure Manual Before StartingStarting Manual Speed switch OFF/RESET positionAmmeter will Starting Auto ModeWhen the generator is set Auto mode, the generator will On position FigureGenerator START-UP Procedure Auto Mode Generator SHUT-DOWN Procedures Normal Shutdown ProcedureOFF/RESET position Emergency Shutdown Procedure Maintenance Engine Replacing Oil Filter Cleaning the Fuel StrainerAir Removal Check Oil LevelMaintenance HEATER/CHARGER Commercial power to theandTo ensure adequate starting Trailer Maintenance Maintenance TrailerActuator Brake AdjustmentBrakes Hydraulic Surge BrakesTires/Wheels/Lug Nuts Tire Wear/InflationSuspension Use an pneumatic air Lug Nut Torque RequirementsTrailer/Towing Vehicle Wiring Diagram Trailer Wiring DiagramGenerator Wiring Diagram Generator Wiring DiagramEngine Wiring Diagram DCA-180SSJU Engine Wiring DiagramGenerator Troubleshooting Troubleshooting GeneratorEngine Controller Troubleshooting Mpec Troubleshooting Engine ControllerDCA-180SSJU Operation and Parts Manual REV. #3 02/01/10 Explanation of Code in Remarks Column Sample Parts ListSuggested Spare Parts Part number on this Suggested Spare Parts listGenerator Assy 0018205020 C01100006020601842334 0601823282Control Panel Assy 022100165 M4223000303M4223000404 022100100Control BOX Assy 0601870423 M32130013020601809666 002710601878 DCA-180SSJU Operation and Parts Manual REV. #3 02/01/10 0027106016 M42605000030602202592 29A 0030006000Engine and Radiator Assy Part Name QTY Remarks Engine and Radiator ASSY. Part Name Output Terminal Assy Output Terminal Assy0039320000 M3230700113M9220100914 M922010100486 DCA-180SSJU Operation and Parts Manual REV. #3 02/01/10 0601812538 M426060010425-1 022100150 0019206020Battery Assy 0602220921 0602220196M9310500404 M9103000504Muffler Assy 0602325066 M43301005020016910025 M4333000303Fuel Tank Assy 0605516090 M43630001020605505070 0605501069Enclosure Assy Enclosure AssyM4423000312 M4413000302M1413400004 0019208020Enclosure ASSY. Enclosure ASSY.0021806016 003790600028A 0041206000 M911300000298 DCA-180SSJU Operation and Parts Manual REV. #3 02/01/10 52A M4493403904 M445300120351A M4493403804 M4453001303Rubber Seals Assy 0228901260 02292012400228900945 0228901200Nameplate and Decals Assy M3550002702 M4550000303M9520100304 M9520100603Freight Policy Terms and Conditions of Sale PartsDCA-180SSJU Operation and Parts Manual REV. #3 02/01/10 HERE’S HOW to GET Help