Multiquip DCA180SSJU operation manual Generator START-UP Procedure Auto Mode

GENERATOR START-UP PROCEDURE (AUTO MODE)

WARNING - AUTO MODE MAINTENANCE

When running the generator in the AUTO mode, remember the generator can start up at any time without warning. NEVER attempt to perform any maintenance when the generator is in the auto mode.

CAUTION - ENGINE SPEED SWITCH

The	must be set to the “High”
position when running in the	mode. Failing to

set the switch in the proper position can result in damage to your generator when it turns on.

When starting generator in AUTO mode use the " Start-up" procedure except where noted (see below).

1.	Perform steps 1 through 6 in the	section
	as outlined in the	.
2.	Place the	(Figure 56) in the HIGH
	position

Figure 56. Engine Speed Switch (High)

3. Place the	(Figure 57) in the
AUTO position

When the MPEC

is placed in the AUTO position,

NOTE the engine glow plugs will be warmed and the engine will start automatically.

Figure 57. MPEC Control Switch (AUTO)

4.Continue operating the generator as s outlined in the procedure (start at step 5).

DCA-180SSJU — OPERATION AND PARTS MANUAL — REV. #3 (02/01/10) — PAGE 55