GENERATOR OUTPUTS
Generator Output Voltages
A wide range of voltages are available to supply voltage for many different applications. Voltages are selected by apply-
ing jumpers (6) to the(Figure 16). To obtain some of the voltages as listed in Table 7 (see be- low) will require a fine adjustment using the
(VR) | located on the control panel. |
Voltage Change-Over Board
The(Figure 16) is located on the control box, behind the generator control panel. This board has been provided for ease of voltage selection.
Figure 16. Voltage Change-Over Board
Maximum Amps
Table 8 shows the amps the generator can pro- vide. DO NOT exceed the maximum amps as listed.
Table 8. Generator Maximum Amps
Rated Voltage | Maximum Amps | |
|
| |
Single Phase | 400 amps (4 wire) | |
120 Volt | ||
| ||
|
| |
Single Phase | 200 amps (4 wire) | |
240 Volt | ||
| ||
|
| |
Three Phase | 433 amps | |
240 Volt | ||
| ||
|
| |
Three Phase | 216 amps | |
480 Volt | ||
| ||
|
|
CAUTION - CHANGING VOLTAGES
NEVER attempt to place jumper plates on the
while the generator is in operation. There exist the possibility of
!
Table 7. Voltages Available
Three Phase | 208V | 220V | 240V | 416V | 440V | 480V | |
(Selectable) | |||||||
|
|
|
|
|
| ||
|
|
|
|
|
|
| |
Single Phase | 120V | 127V | 139V | 240V | 254V | 277V | |
(Selectable) | |||||||
|
|
|
|
|
| ||
|
|
|
|
|
|
|
PAGE 44 —