Kohler 36VDC, 6VSG, 24VDC, 48VDC manual Nameplate, Emission Information

Page 10

Nameplate

The following illustration shows a typical generator set nameplate. Copy the model, serial, and specification numbers from the nameplate into the spaces provided in the product information section on the inside front cover of this manual. See the service views in Section 1.7 for the nameplate location.

GM12070

Figure 3 Typical Nameplate

Emission Information

The Kohler Model CH740 engine used on the 6VSG generator set is certified to operate using natural gas or LPG fuel.

The Emission Compliance Period referred to on the Emission Control or Air Index label indicates the number of operating hours for which the engine has been shown to meet CARB or EPA emission

requirements. Figure 4 provides the engine compliance period (in hours) associated with the category descriptor, which may be found on the certification label.

Emission Compliance Period

EPA

Category C

Category B

Category A

 

250 hours

500 hours

1000 hours

 

 

 

 

CARB

Moderate 125

Intermediate

Extended 500

 

hours

250 hours

hours

 

 

 

 

Figure 4 Emission Compliance Period

Refer to the certification label for engine displacement. The exhaust emission control system for the CH740 engines (6VSG) is EM for U.S. EPA, California, and Europe. See Figure 1-2for engine certification label location.

10 Introduction

TP-6843 1/13

Image 10
Contents VSC TP-6843 1/13aGenerator Set Identification Numbers Product Identification InformationController Identification Engine IdentificationTable of Contents Scheduled Maintenance Table of ContentsAppendix a Abbreviations Battery Safety Precautions and InstructionsAccidental Starting Engine Backfire/Flash Fire Exhaust SystemUse extreme care when handling, storing, and using fuels Fuel System Hazardous NoiseHeavy Equipment Hot PartsIntroduction List of Related LiteratureNameplate Emission InformationService Assistance Service Assistance TP-6843 1/13 Generator Set Enclosure Descriptions and Service ViewsIntroduction Engine AlternatorOnCue Generator Management System AccessoriesCarburetor Heater Programmable Interface Module PIMService Views 3Optional Communications Kit Components Generator Set Operation Prestart ChecklistTheory of Operation Exercising the Generator Set Generator Set OperationExercise FaultsShutdowns Resetting the Controller After a Fault Shutdown Fault Message ShutdownSD Condition Check5Controller Fault Messages Generator Set Operation TP-6843 1/13 VSC Controller Operation Control and IndicatorsVSC Generator Set Controller LED Indicators Controller Keypad6Autopaging Displays, Automatic Mode LCD DisplayChanging Settings Controller PowerBattery Charging Procedure to Change Settings7Changing Settings Changing the Exercise Settings Setting the ExerciserSetting the Exerciser at Controller Power-up Procedure to Set the Exerciser8Procedure to Set the Exerciser on the VSC Controller VSC Controller Menus Main MenuOverview Menu Engine Metering MenuGenerator Metering Menu CalibrationGenerator Set Information Menu Genset Run Time MenuSystem Parameters for Battery Bank Charging Genset System MenuNominal Voltage 24V 36V 48V System Voltage, VDC Setting the Exerciser Adjusting the Display ContrastDate and Time Menu Networking Information MenusNetworking Status Submenu DhcpNetworking Configuration Submenu OnCue Password PasswordRbus Information RbusRemote Devices Submenu 25Remote Devices SubmenuProgrammable Interface Module PIM Status Menu Procedure to View Event History Event LogVSC Controller Operation TP-6843 1/13 Scheduled Maintenance Scheduled MaintenanceService Schedule, 6VSG Models FuelLow Oil Pressure Shutdown Oil Change ProcedureLubrication System Oil CheckResetting the Maintenance Timer Spark PlugsPrecleaner Service Air Cleaner ServicePaper Element Service Engine Starting Battery Cooling SystemFuel System Storage ProcedureLubricating System Cylinder LubricationBattery Controller Service Access TroubleshootingFault Messages IntroductionTroubleshooting Problem Possible Cause Recommended ActionAppendix a Abbreviations AbdcSysteme international d’unites TP-6843 1/13 Appendix Appendix TP-6843 1/13 Page 2012, 2013 by Kohler Co. All rights reserved