Kohler 24VDC, 6VSG, 36VDC, 48VDC manual 25Remote Devices Submenu

Page 41

3.16.4 Remote Devices Submenu

Check the status of remote devices communicating through RBUS (see Figure 3-25). Device types can include:

Programmable Interface Module (PIM)

The serial numbers for the PIM are printed on the circuit boards inside the enclosures.

From Figure 3-24:

Remote ---->

Devices

S/N: XXXXXXXXX

<<*DeviceType*>>

Module Status:

Connected

Comm. Errors: 12345

Comm. Timeouts: 12345

Module ID: 12

Firmware Ver.: 122

(Dis)Connected: MM/DD/YY 12:12 PM

Return ---->

S/N: XXXXXXXXX	<---- Return
<<DeviceType>>

Connected: Displays the date and time that the device was connected.

Disconnected: Displays the last date and time of successful communication.

tp6804

Figure 3-25Remote Devices Submenu

TP-6843 1/13

Section 3 VSC Controller Operation 41

Image 41

Contents TP-6843 1/13a VSCController Identification Product Identification InformationGenerator Set Identification Numbers Engine IdentificationTable of Contents Appendix a Abbreviations Table of ContentsScheduled Maintenance Accidental Starting Safety Precautions and InstructionsBattery Exhaust System Engine Backfire/Flash FireFuel System Hazardous Noise Use extreme care when handling, storing, and using fuelsHot Parts Heavy EquipmentList of Related Literature IntroductionEmission Information NameplateService Assistance Service Assistance TP-6843 1/13 Introduction Engine Descriptions and Service ViewsGenerator Set Enclosure AlternatorCarburetor Heater AccessoriesOnCue Generator Management System Programmable Interface Module PIMService Views 3Optional Communications Kit Components Theory of Operation Prestart ChecklistGenerator Set Operation Generator Set Operation Exercising the Generator SetShutdowns FaultsExercise Fault Message ShutdownSD Condition Check Resetting the Controller After a Fault Shutdown5Controller Fault Messages Generator Set Operation TP-6843 1/13 VSC Generator Set Controller Control and IndicatorsVSC Controller Operation Controller Keypad LED IndicatorsLCD Display 6Autopaging Displays, Automatic ModeBattery Charging Controller PowerChanging Settings Procedure to Change Settings7Changing Settings Setting the Exerciser at Controller Power-up Setting the ExerciserChanging the Exercise Settings Procedure to Set the Exerciser8Procedure to Set the Exerciser on the VSC Controller Main Menu VSC Controller MenusEngine Metering Menu Overview MenuCalibration Generator Metering MenuGenset Run Time Menu Generator Set Information MenuGenset System Menu System Parameters for Battery Bank ChargingNominal Voltage 24V 36V 48V System Voltage, VDC Adjusting the Display Contrast Setting the ExerciserNetworking Information Menus Date and Time MenuDhcp Networking Status SubmenuPassword Networking Configuration Submenu OnCue PasswordRbus Rbus Information25Remote Devices Submenu Remote Devices SubmenuProgrammable Interface Module PIM Status Menu Event Log Procedure to View Event HistoryVSC Controller Operation TP-6843 1/13 Scheduled Maintenance Scheduled MaintenanceFuel Service Schedule, 6VSG ModelsLubrication System Oil Change ProcedureLow Oil Pressure Shutdown Oil CheckSpark Plugs Resetting the Maintenance TimerPaper Element Service Air Cleaner ServicePrecleaner Service Cooling System Engine Starting BatteryLubricating System Storage ProcedureFuel System Cylinder LubricationBattery Fault Messages TroubleshootingController Service Access IntroductionProblem Possible Cause Recommended Action TroubleshootingAbdc Appendix a AbbreviationsSysteme international d’unites TP-6843 1/13 Appendix Appendix TP-6843 1/13 Page 2012, 2013 by Kohler Co. All rights reserved