Kohler 6VSG, 24VDC, 36VDC, 48VDC manual Generator Metering Menu, Calibration

Page 32

3.11 Generator Metering Menu

The generator metering menu displays the generator voltage and % load. See Figure 3-12.

3.11.1Calibration

!DANGER

Hazardous voltage.

Will cause severe injury or death.

This equipment must be installed and serviced by qualified electrical personnel.

The calibration mode can be entered from the

Generator Metering menu. Contact a

Kohler-authorized distributor/dealer for service.

The Reset Calibration menu allows you to set the readings back to the default settings after calibration, if necessary. See Figure 3-12.

	Generator ---->	Volts:
	Metering	Volts:	54.0V
	Metering		54.0V
		Load:	73%
			73%
		Reset	Reset
		Calibration	Calib? No
		<---- Return
			Reset
			Calib? Yes
		Calibration
		Reset

Figure 3-12Generator Metering Menu

32 Section 3 VSC Controller Operation

TP-6843 1/13

Image 32

Contents VSC TP-6843 1/13aProduct Identification Information Controller IdentificationGenerator Set Identification Numbers Engine IdentificationTable of Contents Appendix a Abbreviations Table of ContentsScheduled Maintenance Accidental Starting Safety Precautions and InstructionsBattery Engine Backfire/Flash Fire Exhaust SystemUse extreme care when handling, storing, and using fuels Fuel System Hazardous NoiseHeavy Equipment Hot PartsIntroduction List of Related LiteratureNameplate Emission InformationService Assistance Service Assistance TP-6843 1/13 Descriptions and Service Views Introduction EngineGenerator Set Enclosure AlternatorAccessories Carburetor HeaterOnCue Generator Management System Programmable Interface Module PIMService Views 3Optional Communications Kit Components Theory of Operation Prestart ChecklistGenerator Set Operation Exercising the Generator Set Generator Set OperationShutdowns FaultsExercise Resetting the Controller After a Fault Shutdown Fault Message ShutdownSD Condition Check5Controller Fault Messages Generator Set Operation TP-6843 1/13 VSC Generator Set Controller Control and IndicatorsVSC Controller Operation LED Indicators Controller Keypad6Autopaging Displays, Automatic Mode LCD DisplayController Power Battery ChargingChanging Settings Procedure to Change Settings7Changing Settings Setting the Exerciser Setting the Exerciser at Controller Power-upChanging the Exercise Settings Procedure to Set the Exerciser8Procedure to Set the Exerciser on the VSC Controller VSC Controller Menus Main MenuOverview Menu Engine Metering MenuGenerator Metering Menu CalibrationGenerator Set Information Menu Genset Run Time MenuSystem Parameters for Battery Bank Charging Genset System MenuNominal Voltage 24V 36V 48V System Voltage, VDC Setting the Exerciser Adjusting the Display ContrastDate and Time Menu Networking Information MenusNetworking Status Submenu DhcpNetworking Configuration Submenu OnCue Password PasswordRbus Information RbusRemote Devices Submenu 25Remote Devices SubmenuProgrammable Interface Module PIM Status Menu Procedure to View Event History Event LogVSC Controller Operation TP-6843 1/13 Scheduled Maintenance Scheduled MaintenanceService Schedule, 6VSG Models FuelOil Change Procedure Lubrication SystemLow Oil Pressure Shutdown Oil CheckResetting the Maintenance Timer Spark PlugsPaper Element Service Air Cleaner ServicePrecleaner Service Engine Starting Battery Cooling SystemStorage Procedure Lubricating SystemFuel System Cylinder LubricationBattery Troubleshooting Fault MessagesController Service Access IntroductionTroubleshooting Problem Possible Cause Recommended ActionAppendix a Abbreviations AbdcSysteme international d’unites TP-6843 1/13 Appendix Appendix TP-6843 1/13 Page 2012, 2013 by Kohler Co. All rights reserved