Kohler 6VSG, 24VDC, 36VDC, 48VDC manual Battery

Page 52

4.8.5Battery

Perform battery storage last.

1.Press the OFF button on the generator set controller.

2.Disconnect the battery, negative (–) lead first.

3.Clean the battery.

4.Place the battery in a warm, dry location.

5.Connect the battery to a float/equalize battery charger, or charge the battery monthly using a trickle charger. Follow the battery charger manufacturer’s recommendations.

52 Section 4 Scheduled Maintenance

TP-6843 1/13

Image 52

Contents VSC TP-6843 1/13aProduct Identification Information Controller IdentificationGenerator Set Identification Numbers Engine IdentificationTable of Contents Scheduled Maintenance Table of ContentsAppendix a Abbreviations Battery Safety Precautions and InstructionsAccidental Starting Engine Backfire/Flash Fire Exhaust SystemUse extreme care when handling, storing, and using fuels Fuel System Hazardous NoiseHeavy Equipment Hot PartsIntroduction List of Related LiteratureNameplate Emission InformationService Assistance Service Assistance TP-6843 1/13 Descriptions and Service Views Introduction EngineGenerator Set Enclosure AlternatorAccessories Carburetor HeaterOnCue Generator Management System Programmable Interface Module PIMService Views 3Optional Communications Kit Components Generator Set Operation Prestart ChecklistTheory of Operation Exercising the Generator Set Generator Set OperationExercise FaultsShutdowns Resetting the Controller After a Fault Shutdown Fault Message ShutdownSD Condition Check5Controller Fault Messages Generator Set Operation TP-6843 1/13 VSC Controller Operation Control and IndicatorsVSC Generator Set Controller LED Indicators Controller Keypad6Autopaging Displays, Automatic Mode LCD DisplayController Power Battery ChargingChanging Settings Procedure to Change Settings7Changing Settings Setting the Exerciser Setting the Exerciser at Controller Power-upChanging the Exercise Settings Procedure to Set the Exerciser8Procedure to Set the Exerciser on the VSC Controller VSC Controller Menus Main MenuOverview Menu Engine Metering MenuGenerator Metering Menu CalibrationGenerator Set Information Menu Genset Run Time MenuSystem Parameters for Battery Bank Charging Genset System MenuNominal Voltage 24V 36V 48V System Voltage, VDC Setting the Exerciser Adjusting the Display ContrastDate and Time Menu Networking Information MenusNetworking Status Submenu DhcpNetworking Configuration Submenu OnCue Password PasswordRbus Information RbusRemote Devices Submenu 25Remote Devices SubmenuProgrammable Interface Module PIM Status Menu Procedure to View Event History Event LogVSC Controller Operation TP-6843 1/13 Scheduled Maintenance Scheduled MaintenanceService Schedule, 6VSG Models FuelOil Change Procedure Lubrication SystemLow Oil Pressure Shutdown Oil CheckResetting the Maintenance Timer Spark PlugsPrecleaner Service Air Cleaner ServicePaper Element Service Engine Starting Battery Cooling SystemStorage Procedure Lubricating SystemFuel System Cylinder LubricationBattery Troubleshooting Fault MessagesController Service Access IntroductionTroubleshooting Problem Possible Cause Recommended ActionAppendix a Abbreviations AbdcSysteme international d’unites TP-6843 1/13 Appendix Appendix TP-6843 1/13 Page 2012, 2013 by Kohler Co. All rights reserved