Assembly
Read entire operator’s manual before you attempt to assemble or operate your new pressure washer.
Your pressure washer requires some assembly and is ready for use after it has been properly serviced with the recommended oil and fuel.
If you have any problems with the assembly of your pressure washer, please call the pressure washer helpline at
(800)
Unpack Pressure Washer
1.Remove the parts bag, accessories, and inserts included with pressure washer.
2.Open carton completely by cutting each corner from top to bottom.
3.Ensure you have all included items prior to assembly.
Items in the carton include:
•Main Unit
•Handle
•Cleaning Tanks Assembly
•High Pressure Hose
•Spray Gun
•Nozzle Extension with Quick Connect Fitting
•Plastic Accessory Tray
•Oil Bottle
•Parts Bag (which includes the following):
•Safety Goggles
•Operator’s Manual
•Owner’s Registration Card
•Bag of 4
•Handle/Accessory Tray Fastening Hardware Kit (which includes):
•‘L’ Bolt (1)
•Carriage Bolts (2)
•Plastic Knobs (3)
•Tree Clips (6)
To prepare your pressure washer for operation, you will need to perform these tasks:
1.Fill out and send in registration card.
2.Attach handle, cleaning tanks and accessory tray to main unit.
3.Connect detergent siphon hose to pump.
4.Add oil to engine crankcase.
5.Add fuel to fuel tank.
6.Connect high pressure hose to spray gun and pump.
7.Connect water supply to pump.
8.Attach nozzle extension to spray gun.
9.Select/attach quick connect ProjectPro® nozzle to nozzle extension.
8
Attach Handle, Cleaning Tanks and Accessory Tray
1.Place handle (A) onto handle supports (B) connected to main unit. Make sure holes (C) in handle align with holes (C) on handle supports.
A
C
B
NOTE: It may be necessary to move the handle supports from side to side in order to align the handle so it will slide over the handle supports.
2.Place cleaning tanks over holes on handle (viewing from rear of unit).
3.Insert carriage bolts (D) through top holes of cleaning tanks, the handle and handle supports from rear of unit and attach a plastic knob (E) from front of unit. Tighten by hand.
E |
D |
4.Push tree clips (F) into bottom holes (G) until they sit flat against cleaning tanks (H).
H
G
F
5.Place accessory tray (J) over holes (K) on handle (viewing from front of unit). Push the tree clips (L) into the holes until they sit flat against the accessory tray.
L |
K |
J |
BRIGGSandSTRATTON.COM |